Lesson plan

apparent viscosity

fluid is higher when measured at a higher shear rate ( is higher than ), while the apparent viscosity of a Bingham plastic is lower ( is lower than ). In fluid mechanics, apparent viscosity (sometimes denoted ) is the shear stress applied to a fluid divided by the shear rate: : \eta = \frac{\tau}{\dot\gamma} For a Newtonian fluid, the apparent viscosity is constant, and equal to the Newtonian viscosity of the fluid, but for non-Newtonian fluids, the apparent viscosity depends on the shear rate. Apparent viscosity has the SI derived unit Pa·s (Pascal-second), but the centipoise is frequently used in practice: (1 mPa·s = 1 cP).

Back to article

Article summary

fluid is higher when measured at a higher shear rate ( is higher than ), while the apparent viscosity of a Bingham plastic is lower ( is lower than ). In fluid mechanics, apparent viscosity (sometimes denoted ) is the shear stress applied to a fluid divided by the shear rate: : \eta = \frac{\tau}{\dot\gamma} For a Newtonian fluid, the apparent viscosity is constant, and equal to the Newtonian viscosity of the fluid, but for non-Newtonian fluids, the apparent viscosity depends on the shear rate. Apparent viscosity has the SI derived unit Pa·s (Pascal-second), but the centipoise is frequently used in practice: (1 mPa·s = 1 cP).

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.