Atari SIO

Article summary

The Serial Input/Output system, universally known as SIO, was a proprietary peripheral bus and related software protocol stacks used on the Atari 8-bit computers to provide most input/output duties for those computers. Unlike most I/O systems of the era, such as RS-232, SIO included a lightweight protocol that allowed multiple devices to be attached to a single daisy-chained port that supported dozens of devices. It also supported plug-and-play operations. SIO's designer, Joe Decuir, credits his work on the system as the basis of USB. SIO was developed in order to allow expansion without using internal card slots as in the Apple II, due to problems with the FCC over radio interference. This required it to be fairly flexible in terms of device support. Devices that used the SIO interface included printers, floppy disk drives, cassette decks, modems and expansion boxes. Some devices had ROM based drivers that were copied to the host computer when booted allowing new devices to be supported without native support built into the computer itself. SIO required logic in the peripherals to support the protocols, and in some cases a significant amount of processing power was required - the Atari 810 floppy disk drive included a MOS Technology 6507 for instance. Additionally, the large custom connector was expensive.…

Key claims

No claims recorded.

Discussion questions

1. Summarise the article in your own words. Which single claim would you verify first, and why?
2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.