Lesson plan

Automation Master

Automation Master is an open source community maintained project. Automation Master was created to assist in the design, implementation and operation of an automated system. The installation and startup of any automated system is very time-consuming and costly. Much of the time spent starting up an automated system can be traced to the difficulties in providing an effective test of the computer based system in the integrator's laboratory. Traditional testing techniques required staging as much of the equipment as practical in the laboratory, and wiring up a simulator panel containing switches and indicator lights to all of the I/O modules on the PLC. The operator stations would be connected up to this "rats nest" of wires, switches, indicator lights, and equipment for the test. PLC software would be tested by sequencing the toggle switches to input the electrical signals to the input cards on the PLC, and then observing the response by software on the indicator lights and operator consoles. For small simple systems, this type of testing was manageable, and resulted in some degree of confidence that the control software would work once it was installed. However, the amount of time spent performing the test was relatively high, and a real-time test could not be achieved.…

Back to article

Article summary

Automation Master is an open source community maintained project. Automation Master was created to assist in the design, implementation and operation of an automated system. The installation and startup of any automated system is very time-consuming and costly. Much of the time spent starting up an automated system can be traced to the difficulties in providing an effective test of the computer based system in the integrator's laboratory. Traditional testing techniques required staging as much of the equipment as practical in the laboratory, and wiring up a simulator panel containing switches and indicator lights to all of the I/O modules on the PLC. The operator stations would be connected up to this "rats nest" of wires, switches, indicator lights, and equipment for the test. PLC software would be tested by sequencing the toggle switches to input the electrical signals to the input cards on the PLC, and then observing the response by software on the indicator lights and operator consoles. For small simple systems, this type of testing was manageable, and resulted in some degree of confidence that the control software would work once it was installed. However, the amount of time spent performing the test was relatively high, and a real-time test could not be achieved.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.