Lesson plan
Blend time
Blend time, sometimes termed mixing time, is the time to achieve a predefined level of homogeneity of a tracer in a mixing vessel. Blend time is an important parameter to evaluate the mixing efficiency of mixing devices. In order to make this definition valid, the tracer should be in the same physical phase (e.g. liquid) as the bulk material. Blend time can be determined either with experiments or numerical modeling, such as computational fluid dynamics (CFD). The experimental methods to determine the blend time in liquid include conductivity method and discoloration method. The conductivity method requires a conductivity probe to present in the target system, which make it an intrusive method because the existence of the probe might change the mixing efficiency of the mixing device. Discoloration method does not require any probe which makes it a non-intrusive method. However, the color detection device (sometimes the human eye) needs to be calibrated against the conductivity method. Both methods are usually applied to monitor the concentration of the tracer in the most difficult to mix locations such as the area adjacent to the impeller shaft.…
Article summary
Blend time, sometimes termed mixing time, is the time to achieve a predefined level of homogeneity of a tracer in a mixing vessel. Blend time is an important parameter to evaluate the mixing efficiency of mixing devices. In order to make this definition valid, the tracer should be in the same physical phase (e.g. liquid) as the bulk material. Blend time can be determined either with experiments or numerical modeling, such as computational fluid dynamics (CFD). The experimental methods to determine the blend time in liquid include conductivity method and discoloration method. The conductivity method requires a conductivity probe to present in the target system, which make it an intrusive method because the existence of the probe might change the mixing efficiency of the mixing device. Discoloration method does not require any probe which makes it a non-intrusive method. However, the color detection device (sometimes the human eye) needs to be calibrated against the conductivity method. Both methods are usually applied to monitor the concentration of the tracer in the most difficult to mix locations such as the area adjacent to the impeller shaft.…
Key claims
No claims recorded.
Discussion questions
- Summarise the article in your own words. Which single claim would you verify first, and why?
- Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
- If two sources disagreed about one of these facts, what would you need in order to trust one over the other?
Bibliography
No sources recorded.
Key claims and bibliography are generated from the same tracked claims and sources as the article page.