Lesson plan
Clearing factor
In centrifugation the clearing factor or k factor represents the relative pelleting efficiency of a given centrifuge rotor at maximum rotation speed. It can be used to estimate the time t (in hours) required for sedimentation of a fraction with a known sedimentation coefficient s (in svedbergs): : t = \frac{k}{s} The value of the clearing factor depends on the maximum angular velocity \omega of a centrifuge (in rad/s) and the minimum and maximum radius r of the rotor: : k = \frac{\ln(r_{\rm{max}} / r_{\rm{min}})}{\omega^2} \times \frac{10^{13}}{3600} As the rotational speed of a centrifuge is usually specified in RPM, the following formula is often used for convenience: : k = \frac{2.53 \cdot 10^5 \times \ln(r_{\rm{max}} / r_{\rm{min}})}{(\rm{RPM}/1000)^2} Centrifuge manufacturers usually specify the minimum, maximum and average radius of a rotor, as well as the k factor of a centrifuge-rotor combination. For runs with a rotational speed lower than the maximum rotor-speed, the k factor has to be adjusted: : k_{\rm{adj}} = k \left( \frac{\mbox{maximum rotor-speed}}{\mbox{actual rotor-speed}} \right) 2 The K-factor is related to the sedimentation coefficient S by the formula: T = \frac{K}{S} Where T is the time to pellet a certain particle in hours. Since S is a constant for a certain particle, this relationship can be used to interconvert between different rotors.…
Article summary
In centrifugation the clearing factor or k factor represents the relative pelleting efficiency of a given centrifuge rotor at maximum rotation speed. It can be used to estimate the time t (in hours) required for sedimentation of a fraction with a known sedimentation coefficient s (in svedbergs): : t = \frac{k}{s} The value of the clearing factor depends on the maximum angular velocity \omega of a centrifuge (in rad/s) and the minimum and maximum radius r of the rotor: : k = \frac{\ln(r_{\rm{max}} / r_{\rm{min}})}{\omega^2} \times \frac{10^{13}}{3600} As the rotational speed of a centrifuge is usually specified in RPM, the following formula is often used for convenience: : k = \frac{2.53 \cdot 10^5 \times \ln(r_{\rm{max}} / r_{\rm{min}})}{(\rm{RPM}/1000)^2} Centrifuge manufacturers usually specify the minimum, maximum and average radius of a rotor, as well as the k factor of a centrifuge-rotor combination. For runs with a rotational speed lower than the maximum rotor-speed, the k factor has to be adjusted: : k_{\rm{adj}} = k \left( \frac{\mbox{maximum rotor-speed}}{\mbox{actual rotor-speed}} \right) 2 The K-factor is related to the sedimentation coefficient S by the formula: T = \frac{K}{S} Where T is the time to pellet a certain particle in hours. Since S is a constant for a certain particle, this relationship can be used to interconvert between different rotors.…
Key claims
No claims recorded.
Discussion questions
- Summarise the article in your own words. Which single claim would you verify first, and why?
- Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
- If two sources disagreed about one of these facts, what would you need in order to trust one over the other?
Bibliography
No sources recorded.
Key claims and bibliography are generated from the same tracked claims and sources as the article page.