Clipping (audio)

Uses your system voice; voice and rate in settings.

Snapshot

≈ 3 min read

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

form displayed on this oscilloscope indicate the signal has been "clipped." Clipping is a form of waveform distortion that occurs when an amplifier is overdriven and attempts to deliver an output voltage or current beyond its maximum capability. Driving an amplifier into clipping may cause it to output power in excess of its power rating. In the frequency domain, clipping produces strong harmonics in the high-frequency range (as the clipped waveform comes closer to a square wave). The extra high-frequency weighting of the signal could make tweeter damage more likely than if the signal were not clipped. In most cases, the distortion associated with clipping is unwanted, and is visible on an oscilloscope even if it is inaudible. However, clipping is often used in music for artistic effect, particularly guitar-dominant genres like blues, rock, and metal.

form displayed on this oscilloscope indicate the signal has been "clipped."]] Clipping is a form of waveform distortion that occurs when an amplifier is overdriven and attempts to deliver an output voltage or current beyond its maximum capability. Driving an amplifier into clipping may cause it to output power in excess of its power rating. In the frequency domain, clipping produces strong harmonics in the high-frequency range (as the clipped waveform comes closer to a square wave). The extra high-frequency weighting of the signal could make tweeter damage more likely than if the signal were not clipped. In most cases, the distortion associated with clipping is unwanted, and is visible on an oscilloscope even if it is inaudible. However, clipping is often used in music for artistic effect, particularly guitar-dominant genres like blues, rock, and metal.

Detection

Clipping in a circuit can be detected by comparing the original input signal with an output signal with adjustment for applied gain. For instance, if a circuit has 10 dB of applied gain, it can be tested for clipping by attenuating the output signal by 10 dB and comparing it to the input signal. The difference between the two signals can be used to illuminate clipping detection indicators and can be used to decrease the gain of a preceding circuit to manage clipping. Clipped signals will often be squarized, where third harmonics are contextual outliers in a Fourier Transform. In the case of an expected sine wave, the presence of odd harmonics will often suggest the signal has been hard clipped. A “soft clip” will have a knee on both sides of the plateau, which will show the presence of several even overtones in the lower frequency spectrum.

Text derived from https://en.wikipedia.org/w/index.php?oldid=1377665544 under CC BY-SA 4.0; modifications have been made.

Sources cited in this revision

7 named source(s) extracted from the cited revision. A source with no author is shown by its publication; nothing is invented.