Clothing insulation

Clothing insulation is the thermal insulation provided by clothing.

Uses your system voice; voice and rate in settings.

≈ 7 min read

Cite, export and learn8 citation formats · 8 exports · lesson and quiz

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

Clothing insulation is the thermal insulation provided by clothing. Even if the main role of clothing is to protect from the cold, protective clothing also exists to protect from heat, such as for metallurgical workers or firemen. As regards thermal comfort, only the first case is considered.

Mechanisms of insulation

There are three kinds of heat transfer: conduction (exchange of heat through contact), convection (movement of fluids), and radiation. Air has a low thermal conductivity but is very mobile.

There are thus two elements that are important in protecting from the cold: setting up a layer of still air which serves as insulation, by the use of fibres (wool, fur, et cetera) stopping the wind from penetrating and replacing the layer of warm air close to the body Another important factor is humidity. Water is a better conductor of heat than air, thus if clothes are damp — because of sweat, rain, or immersion — water replaces some or all of the air between the fibres of the clothing, causing thermal loss through conduction and/or evaporation.

Thermal insulation is thus optimal with three layers of clothing: a layer near the body for hygiene (changed more often than the other clothing), whose role is to get rid of sweat so it does not remain in contact with the skin; an outer close-knit or closely woven layer as a wind breaker, usually thin — if there is a risk of precipitation this should be impermeable, the ideal being a textile that stops water droplets but allows water vapor to pass so as to remove evaporated sweat (a textile of this sort is said to "breathe"); and between the two, a "thick" layer that traps the air and prevents contact between the skin and the wind-breaking layer (which, as it is thin, gets close to the ambient temperature). The layers of trapped air between the skin and the exterior surface play a major insulating role.

If the clothing is squeezed tight (as by the straps of a backpack), insulation will be poorer in those places. Insulation is improved when convection in the air layers is minimised.

Units and measurement

Clothing insulation may be expressed in clo units. The clo has the same dimensions as the R value (square metre kelvins per watt or m 2 ⋅K/W) used to describe insulation used in residential and commercial construction—thus, the higher the value, the better the insulation performance.

1 clo = 0.155 K·m 2 ·W −1 ≈ 0.88 K·m 2 ·BTU·W −1 ·ft −2 ·°F −1 ·hr −1 R. One clo is the amount of insulation that allows a person at rest to maintain thermal equilibrium in an environment at 21°C (70°F) in a normally ventilated room (0.1 m/s air movement). There are a number of ways to determine clothing insulation provided by clothes, but the most accurate according to ASHRAE Fundamentals are measurements on heated manikins and on active subjects.

Equations may then be used to calculate the thermal insulation. Because clothing insulation cannot be measured for most routine engineering applications, tables of measured values for various clothing ensembles can be used. According to ASHRAE-55 2010 standard, there are three methods for estimating clothing insulation using the tables provided.

If the ensemble in question matches reasonably well with one on Table 1, the indicated value of intrinsic clothing insulation can be used; It is acceptable to add or subtract garments on Table 2 from the ensembles in Table 1 to estimate the insulation of ensembles that differ in garment composition; It is possible to define a complete clothing ensemble as a combination of individual garments using Table 2. Another unit that is used is the "tog": 1 tog = 0.1 K·m 2 ·W −1 ≈ 0.645 clo 1 clo = 1.55 togs The name comes from the word "togs", British slang for clothes.

Clothing ensembles and garments

Icl is intrinsic clo, which is the clo of the garment * the percent of body surface area covered by that garment. Thus, you can add up the intrinsic clo of all the garments and get the total clo of your body.

Clothing Insulation for Outdoors

The above applies more to clothing worn indoors. It references the ASHRAE handbook which is used to design HVAC systems for indoor spaces. Outdoors the temperature range is much larger, and the exertion level range can be much higher so clothing is different.

When it's cold, if the skin temperature gets below 30 C (86 F) the human will be uncomfortable. The goal of clothing insulation is to keep the skin temperature at that temperature or above.

Comfort The skin temperature can be determined using the differential form of Fouriers Law (Thermal conduction). q = - k · \nabla T where (including the SI units) q is the local heat flux, W / m2 k is the material's conductivity, W/(m·K), \nabla T is the temperature gradient, K/m. Doing a little algebra we can reformulate. k = width / R where width is the thickness of the insulation R is the R value of the insulation in m2K/W and \nabla T = \Delta T / width where \Delta T is the temperature difference across the insulation substituting k and \nabla T and reordering \Delta T = q * R The heat flux (q) of the human body is (Metabolic equivalent of task) q = 58.2 W/m2 · MET where MET is the exertion level. Now we can figure out if we'll be warm.

We know the temperature of the skin when we're just barely warm (30 C = 86 F). If the ambient temperature is greater than (skin temperature - \Delta T), then we'll be warm. This is overly simplistic but it's too complicated to do more than this. Different parts of the body have different heat flux, skin temperature, and insulation.

We can just average over the entire body and we'll be close. Wind, radiant heat loss, and humidity also affect this. We can still make some reasonable conclusions.

R value of different insulations Clo is the unit of insulation used by the clothing industry. 1 Clo is nominally what a person wears in an office, a suit outfit. As used earlier in this article.

Rus is the U.S. unit for insulation (Fft2h/BTU) R is the metric unit for insulation (m2K/W) as used in the formulas above Now, we can look at a number of cases. First, consider the lightest insulation from that table, fleece, at different exertion levels.

Calculate the minimum comfort temperature using the formula above: For example, wearing fleece, when sleeping (MET = 0.8), the minimum temperature where you'll be comfortable is 72 F (22 C). You would have to wear this all over your body. You can see that at high exertion levels, even light insulation is warm down to very cold temperatures.

The result for this cold is inaccurate - the assumptions about equal coverage over the entire body, wind, radiant heat loss, and humidity are too great, but it gives a general idea. There is a useful strategy that comes from this. If you're cold, increase your exertion level.

Next, consider a number of different insulations at a low exertion level: For example, wearing fleece, standing around (MET = 1.5), the minimum temperature where you'll be comfortable is 59 F (15 C). Again, the results for the coldest cases are inaccurate - the assumptions about equal coverage over the entire body, wind, radiant heat loss, and humidity are too great, but it gives a general idea. If you had the heavy insulation over your entire body, you could survive very cold temperatures.

It's important to have insulation over your head. Conventional wisdom is "if you want to keep warm, put a hat on".

Text derived from https://en.wikipedia.org/w/index.php?oldid=1362470620 under CC BY-SA 4.0; modifications have been made.

Words in each sectionClothing Insulation for…Clothing Insulation for OutdoorsClothing Insulation for Outdoors: 641 words641Mechanisms of insulationMechanisms of insulationMechanisms of insulation: 305 words305Units and measurementUnits and measurementUnits and measurement: 296 words296Clothing ensembles and …Clothing ensembles and garmentsClothing ensembles and garments: 41 words41
Words in each section. Measured from the stored article body; sections below the minimum are not plotted.

Provenance

snapshot enwiki-001362470620 · captured 2026-07-04 · ledger · version history

Cite this page as: encyclopegia.org, “Clothing insulation”, snapshot enwiki-001362470620. https://encyclopegia.org/a/clothing-insulation

Sources cited in this revision

12 named source(s) extracted from the cited revision. A source with no author is shown by its publication; nothing is invented.