Clumped isotopes

Clumped isotopes are heavy isotopes that are bonded to other heavy isotopes.

Uses your system voice; voice and rate in settings.

Snapshot

≈ 4 min read

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

Clumped isotopes are heavy isotopes that are bonded to other heavy isotopes. The relative abundance of clumped isotopes (and multiply substituted isotopologues) in molecules such as methane, nitrous oxide, and carbonate is an area of active investigation.

The carbonate clumped-isotope thermometer, or " 13 C– 18 O order/disorder carbonate thermometer", is a new approach for paleoclimate reconstruction, based on the temperature dependence of the clumping of 13 C and 18 O into bonds within the carbonate mineral lattice. This approach has the advantage that the 18 O ratio in water is not necessary (different from the δ 18 O approach), but for precise paleotemperature estimation, it also needs very large and uncontaminated samples, long analytical runs, and extensive replication.

Commonly used sample sources for paleoclimatological work include corals, otoliths, gastropods, tufa, bivalves, and foraminifera. Results are usually expressed as Δ47 (said as "cap 47"), which is the deviation of the ratio of isotopologues of CO 2 with a molecular weight of 47 to those with a weight of 44 from the ratio expected if they were randomly distributed.

Differences from the conventional δ 18 O analysis

In conventional δ 18 O analysis, both the δ 18 O values in carbonates and water are needed to estimate paleoclimate. However, for many times and places, the δ 18 O in water can only be inferred, and also the 16 O/ 18 O ratio between carbonate and water may vary with the change in temperature. Therefore, the accuracy of the thermometer may be compromised.

Whereas for the carbonate clumped-isotope thermometer, the equilibrium is independent of the isotope compositions of waters from which carbonates grew. Therefore, the only information needed is the abundance of bonds between rare, heavy isotopes within the carbonate mineral.

Methods

Extract from carbonates by reaction with anhydrous phosphoric acid. (there is no direct way to measure the abundance of CO with high enough precision). The phosphoric acid temperature is often held between 25° and 90°C and can be as high as 110 °C. Purify the that has been extracted.

This step removes contaminant gases like hydrocarbons and halocarbons which can be removed by gas chromatography. Mass spectrometric analyses of purified , to obtain δ C, δ O, and Δ47 (abundance of mass-47 ) values. (Precision needs to be as high as ≈10 , for the isotope signals of interest are often less than ≈10 .)

Limitations

The temperature dependent relationship is subtle ( ). 13 C 18 O 16 O 2 2− is a rare isotopologue (≈60 ppm [3]). Therefore, to obtain adequate precision, this approach requires long analyses (≈2–3 hours) and very large and uncontaminated samples.

Clumped isotope analyses assume that measured Δ47 is composed of 13 C 18 O 16 O 2 2− , the most common isotopologue of mass 47. Corrections to account for less common isotopologues of mass 47 (e.g. 12 C 18 O 17 O 16 O 2− ) are not completely standardized between labs.

See also

Paleothermometer Isotopic signature Isotope analysis Isotope geochemistry Isotopic labeling

Text derived from https://en.wikipedia.org/w/index.php?oldid=1377694888 under CC BY-SA 4.0; modifications have been made.

Sources cited in this revision

8 named source(s) extracted from the cited revision. A source with no author is shown by its publication; nothing is invented.