Common gate

details); current source I D represents an active load; signal is applied at node V in and output is taken from node V out ; output can be current or voltage In electronics, a common-gate amplifier is one of three basic single-stage field-effect transistor (FET) amplifier topologies, typically used as a current buffer or voltage amplifier. In this circuit, the source terminal of the transistor serves as the input, the drain is the output, and the gate is connected to some DC biasing voltage (i.e. an AC ground), or "common," hence its name. The analogous bipolar junction transistor circuit is the common-base amplifier.

details); current source I D represents an active load; signal is applied at node V in and output is taken from node V out ; output can be current or voltage]] In electronics, a common-gate amplifier is one of three basic single-stage field-effect transistor (FET) amplifier topologies, typically used as a current buffer or voltage amplifier. In this circuit, the source terminal of the transistor serves as the input, the drain is the output, and the gate is connected to some DC biasing voltage (i.e. an AC ground), or "common," hence its name. The analogous bipolar junction transistor circuit is the common-base amplifier. ==Applications== This configuration is used less often than the common source or source follower. However, it can be combined with common source amplifiers to create cascode configurations. It is useful in, for example, CMOS RF receivers, especially when operating near the frequency limitations of the FETs; it is desirable because of the ease of impedance matching and potentially has lower noise. Gray and Meyer provide a general reference for this circuit. ==Low-frequency characteristics== for amplifier driven by a Norton signal source]] At low frequencies and under small-signal conditions, the circuit in Figure 1 can be represented by that in Figure 2, where the hybrid-pi model for the MOSFET has been employed. ]] The amplifier characteristics are summarized below in Table 1. The approximate expressions use the assumptions (usually accurate) r O >> R L and g m r O >> 1. In general, the overall voltage/current gain may be substantially less than the open/short circuit gains listed above (depending on the source and load resistances) due to the loading effect. ===Closed circuit voltage gain=== Taking input and output loading into consideration, the closed circuit voltage gain (that is, the gain with load R L and source with resistance R S both attached) of the common gate can be written as: {A_\mathrm{v}} \approx \begin{matrix} \frac {g_m R_\mathrm{L}} {1+g_mR_S} \end{matrix} , which has the simple limiting forms A_\mathrm{v} = \begin{matrix} \frac {R_L}{R_S}\end{matrix} \ \ \mathrm{ or } \ \ A_\mathrm{v} = g_m R_L , depending upon whether g m R S is much larger or much smaller than one. In the first case the circuit acts as a current follower, as understood as follows: for R S >> 1/g m the voltage source can be replaced by its Norton equivalent with Norton current v Thév / R S and parallel Norton resistance R S . Because the amplifier input resistance is small, the driver delivers by current division a current v Thév / R S to the amplifier. The current gain is unity, so the same current is delivered to the output load R L , producing by Ohm's law an output voltage v out = v Thév R L / R S , that is, the first form of the voltage gain above. In the second case R S m and the Thévenin representation of the source is useful, producing the second form for the gain, typical of voltage amplifiers. Because the input impedance of the common-gate amplifier is very low, the cascode amplifier often is used instead. The cascode places a common-source amplifier between the voltage driver and the common-gate circuit to permit voltage amplification using a driver with R S >> 1/g m . ==References== ==External links== A 24GHz CMOS Front-end

Text derived from https://en.wikipedia.org/w/index.php?oldid=1240759877 under CC BY-SA 4.0; modifications have been made.