Comparator applications

Uses your system voice; voice and rate in settings.

Snapshot

≈ 2 min read

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

A comparator is an electronic component that compares two input voltages. Comparators are closely related to operational amplifiers, but a comparator is designed to operate with positive feedback and with its output saturated at one power rail or the other. If necessary, an op-amp can be pressed into service as a poorly performing comparator, but its slew rate will be impaired.

A comparator is an electronic component that compares two input voltages. Comparators are closely related to operational amplifiers, but a comparator is designed to operate with positive feedback and with its output saturated at one power rail or the other. If necessary, an op-amp can be pressed into service as a poorly performing comparator, but its slew rate will be impaired.

V_{\text{out}} = \begin{cases} V_{\text{S}+} & \text{if } V_1 > V_2, \\ V_{\text{S}-} & \text{if } V_1 where V_{\text{S}+} and V_{\text{S}-} are nominally the positive and negative supply voltages (which are not shown in the diagram). V_+={R_2 \over {R_1 + R_2}}V_{in} + {R_1 \over {R_1 + R_2}}V_{out} Unlike the zero crossing detector, the detector with hysteresis does not switch when Vin is zero; rather the output becomes Vsat+ when Va becomes positive and Vsat- when Va becomes negative.

Further examination of the Va equation reveals that Vin can exceed zero (positive or negative) by a certain magnitude before the output of the detector is caused to switch. By adjusting the value of R1, the magnitude of Vin that will cause the detector to switch can be increased or decreased. Hysteresis is useful in various applications. It has better noise immunity than the level detector, which is used in interface circuits. Its positive feedback has a faster transition, so it is used in timing applications such as frequency counters.

It is also used in astable multivibrators found in instruments such as function generators. f_i=\frac{\Delta t}{2} where \Delta t is the time difference between adjacent zero crossings of FM wave.

Text derived from https://en.wikipedia.org/w/index.php?oldid=1331337915 under CC BY-SA 4.0; modifications have been made.

Sources cited in this revision

4 named source(s) extracted from the cited revision. A source with no author is shown by its publication; nothing is invented.