crankshaft
part of an engine or other machine that is cranked by, or cranks, pistons via connecting rods; is connected to the flywheel
≈ 3 min read
Names in other languages
- ČeštinaKliková hřídel
- beкаленчаты вал
- bgКолянов вал
- Françaisvilebrequin
- boའཁྱོག་མདའ།
- Englishcrankshaft
- العربيةعمود مرفق
- cacigonyal
- afKrukas
Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.
A crankshaft is a mechanical component used in a piston engine to convert the reciprocating motion into rotational motion. The crankshaft is a rotating shaft containing one or more crankpins, that are driven by the pistons via the connecting rods. The crankpins are also called rod bearing journals, and they rotate within the "big end" of the connecting rods.
Most modern crankshafts are located in the engine block. They are made from steel or cast iron, using either a forging, casting or machining process.
Bearings
The crankshaft is able to rotate in the engine block due to the 'main bearings'. Since the crankshaft is subject to large horizontal and torsional forces from each cylinder, these main bearings are located at various points along the crankshaft, rather than just one at each end. The number of main bearings is determined based on the overall load factor and the maximum engine speed.
Crankshafts in diesel engines often use a main bearing between every cylinder and at both ends of the crankshaft, due to the high forces of combustion present. Flexing of the crankshaft was a factor in replacing straight-eight engines in the 1950s; the long crankshafts suffered from an unacceptable amount of flex when engine designers began using higher compression ratios and higher engine speeds (RPM).
Piston stroke
The distance between the axis of the crankpins and the axis of the crankshaft determines the stroke length of the engine. Most modern car engines are classified as "over square" or short-stroke, wherein the stroke is less than the diameter of the cylinder bore. A common way to increase the low-RPM torque of an engine is to increase the stroke, sometimes known as "stroking" the engine.
Historically, the trade-off for a long-stroke engine was a lower rev limit and increased vibration at high RPM, due to the increased piston velocity.
Engine balance
For some engines it is necessary to provide counterweights for the reciprocating mass of the piston, conrods and crankshaft, in order to improve the engine balance. These counterweights are typically cast as part of the crankshaft but, occasionally, are bolt-on pieces.
Flying arms
s on a crankshaft) In some engines, the crankshaft contains direct links between adjacent crankpins, without the usual intermediate main bearing. These links are called flying arms. This arrangement is sometimes used in V6 and V8 engines, in order to maintain an even firing interval while using different V angles, and to reduce the number of main bearings required.
The downside of flying arms is that the rigidity of the crankshaft is reduced, which can cause problems at high RPM or high power outputs.
See also
Bicycle crankset Brace (tool) Cam (mechanism) Cam engine Camshaft Crank (mechanism) Crankcase Crankshaft torsional vibration List of auto parts Piston motion equations Tunnel crankshaft Scotch yoke Swashplate
External links
Interactive crank animation https://www.desmos.com/calculator/8l2kvyivqo D & T Mechanisms – Interactive Tools for Teachers (applets) https://web.archive.org/web/20140714155346/http://www.content.networcs.net/tft/mechanisms.htm
Text derived from https://en.wikipedia.org/w/index.php?oldid=1376334650 under CC BY-SA 4.0; modifications have been made.