Curb cut

A curb cut (U.S.), curb ramp, depressed curb, dropped kerb (UK), pram ramp, or kerb ramp (Australia) is a solid (usually concrete) ramp graded down from the top surface of a sidewalk to the surface of an adjoining street.

Uses your system voice; voice and rate in settings.

Snapshot

≈ 4 min read

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

A curb cut (U.S.), curb ramp, depressed curb, dropped kerb (UK), pram ramp, or kerb ramp (Australia) is a solid (usually concrete) ramp graded down from the top surface of a sidewalk to the surface of an adjoining street. It is designed primarily for pedestrian usage and commonly found in urban areas where pedestrian activity is expected.

In comparison with a conventional curb (finished at a right angle above the street surface) a curb cut is finished at an intermediate gradient that connects both surfaces, sometimes with tactile paving.

History

Historically speaking, footpaths were finished at right angles to the street surface with conventional stepped curb treatments. Their introduction to help people pushing prams dates back at least as far as the 1930s in the UK. Kalamazoo, Michigan installed curb cuts in the 1940s as a pilot project introduced by veteran and lawyer Jack H. Fischer to aid employment of veterans with disabilities.

A major project in Berkeley, California led by the grassroots Center for Independent Living led to curb cuts up and down Telegraph and Shattuck Avenues creating an extensive path of travel. Following this, the value of curb cuts was promoted more strongly and their installation was often made on a voluntary basis by municipal authorities and developers.

Curb cuts in Western countries have been mandated by legislation such as the Americans with Disabilities Act of 1990 (ADA) in the United States (which requires that curb cuts be present on all sidewalks) or the Disability Discrimination Act 1992 in Australia. The legislative requirements in some jurisdictions have been increased from the original requirements in recent times, to the point where existing treatments can now fail to meet the most recent design requirements.

When the ramps are used by a broader population than just the disabled (for whom the curb cut requirement was legislated), this new convenience can be seen as a positive externality, and has become known as the curb cut effect.

Users and uses

Curb cuts at intersections allow for people with disabilities such as wheelchair users to move around safely, independently, and with less difficulty. Curb cuts typically feature tactile paving, a pattern of circular bumps that indicate to visually impaired pedestrians they are about to enter a roadway.

Curb cuts also benefit other pedestrians and wheeled forms of transport, such as people with carts or cyclists. The absence of a curb cut can lead to people with ambulatory disabilities forced to travel in the roadway, along side vehicle traffic. Even when present, a curb cut with a steep or uneven grade can be innavigable or lead to injuries.

Other applications

A wider curb cut is also useful for motor vehicles to enter a driveway or parking lot on the other side of a sidewalk. In the UK this is commonly referred to as a 'crossover'. Smaller curb cuts may be used along streets, parking areas or sidewalks in the manner of a water bar, redirecting water from the pavement to stormwater infiltration infrastructure, such as a grassed area or rain garden.

Design

Accessible curb cuts transition from the low side of a curb to the high side (usually change in level). Accessible curb ramps are a minimum of wide. They are sloped no greater than 1:12 (8.33%), which means that for every of horizontal distance, they rise no more than .

The concrete curb ramp is sometimes scored with grooves, the texture of which may serve as a warning to vision-impaired persons of the transition to the street. Such grooves also allow for traction and water runoff, and may be stained a color that significantly contrasts with the adjacent concrete. If a curb ramp contains flared sides, they are usually no greater than 1:10 (10%) slope.

Pram ramps in Australia are designed according to Australian Standard "AS 1428.1:2021", "Design for access and mobility, Part 1: General requirements for access - New building work".

Text derived from https://en.wikipedia.org/w/index.php?oldid=1356181320 under CC BY-SA 4.0; modifications have been made.

Sources cited in this revision

18 named source(s) extracted from the cited revision. A source with no author is shown by its publication; nothing is invented.