Lesson plan
Cycle stealing
In computing, traditionally cycle stealing is a method of memory (RAM) or bus access without interfering with the CPU. It is similar to direct memory access (DMA) for allowing I/O controllers to read or write RAM without CPU intervention. Clever exploitation of specific CPU or bus timings can permit the CPU to run at full speed without any delay if external devices access memory not actively participating in the CPU's current activity and complete the operations before any possible CPU conflict. Cycle stealing was common in older platforms, first on supercomputers which used complex systems to time their memory access, and later on early microcomputers where cycle stealing was used both for peripherals as well as display drivers. It is more difficult to implement in modern platforms because there are often several layers of memory running at different speeds, and access is often mediated by the memory management unit. In the cases where the functionality is needed, modern systems often use dual-port RAM which allows access by two systems, but this tends to be expensive. In older references, the term is also used to describe traditional DMA systems where the CPU stops during memory transfers. In this case the device is stealing cycles from the CPU, so it is the opposite sense of the more modern usage.…
Article summary
In computing, traditionally cycle stealing is a method of memory (RAM) or bus access without interfering with the CPU. It is similar to direct memory access (DMA) for allowing I/O controllers to read or write RAM without CPU intervention. Clever exploitation of specific CPU or bus timings can permit the CPU to run at full speed without any delay if external devices access memory not actively participating in the CPU's current activity and complete the operations before any possible CPU conflict. Cycle stealing was common in older platforms, first on supercomputers which used complex systems to time their memory access, and later on early microcomputers where cycle stealing was used both for peripherals as well as display drivers. It is more difficult to implement in modern platforms because there are often several layers of memory running at different speeds, and access is often mediated by the memory management unit. In the cases where the functionality is needed, modern systems often use dual-port RAM which allows access by two systems, but this tends to be expensive. In older references, the term is also used to describe traditional DMA systems where the CPU stops during memory transfers. In this case the device is stealing cycles from the CPU, so it is the opposite sense of the more modern usage.…
Key claims
No claims recorded.
Discussion questions
- Summarise the article in your own words. Which single claim would you verify first, and why?
- Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
- If two sources disagreed about one of these facts, what would you need in order to trust one over the other?
Bibliography
No sources recorded.
Key claims and bibliography are generated from the same tracked claims and sources as the article page.