Direct bonding

Direct bonding, or fusion bonding, is a wafer bonding process without any additional intermediate layers.

Uses your system voice; voice and rate in settings.

Snapshot

≈ 3 min read

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

Direct bonding, or fusion bonding, is a wafer bonding process without any additional intermediate layers. It is based on chemical bonds between two surfaces of any material possible meeting numerous requirements. These requirements are specified for the wafer surface as sufficiently clean, flat and smooth.

Otherwise unbonded areas so called voids, i.e. interface bubbles, can occur. The procedural steps of the direct bonding process of wafers any surface is divided into # wafer preprocessing, # pre-bonding at room temperature and # annealing at elevated temperatures.

Even though direct bonding as a wafer bonding technique is able to process nearly all materials, silicon is the most established material up to now. Therefore, the bonding process is also referred to as silicon direct bonding or silicon fusion bonding. The fields of application for silicon direct bonding are, e.g. manufacturing of Silicon on insulator (SOI) wafers, sensors and actuators.

Direct bonding, or fusion bonding, is a wafer bonding process without any additional intermediate layers. It is based on chemical bonds between two surfaces of any material possible meeting numerous requirements. These requirements are specified for the wafer surface as sufficiently clean, flat and smooth.

Otherwise unbonded areas so called voids, i.e. interface bubbles, can occur. The procedural steps of the direct bonding process of wafers any surface is divided into wafer preprocessing, pre-bonding at room temperature and annealing at elevated temperatures.

Even though direct bonding as a wafer bonding technique is able to process nearly all materials, silicon is the most established material up to now. Therefore, the bonding process is also referred to as silicon direct bonding or silicon fusion bonding.

The fields of application for silicon direct bonding are, e.g. manufacturing of Silicon on insulator (SOI) wafers, sensors and actuators. {Si-OH} + Si-OH {Si-O-Si} + HOH No further processes are observed at the interface between 150 °C and 800 °C until all OH-groups are polymerized and the composite strength remains constant. Above 800 °C native oxide gets viscous and starts to flow at the interface, which increases the area of contacted surfaces.

So, the diffusion of trapped hydrogen molecules along the interface is enhanced and interface voids may reduce in size or disappear at all. The annealing process is finished by the cooling of the wafer stack. The interface energy increases to more than 2  at 800 °C with a native oxide layer or at 1000 °C if the wafers are covered by thermal oxide (compare diagram of surface energy).

In case one wafer contains a layer of thermal oxide and the other wafer is covered by a native oxide, the surface energy development is similar to a wafer pair both covered with a native oxide layer.

Text derived from https://en.wikipedia.org/w/index.php?oldid=1345590243 under CC BY-SA 4.0; modifications have been made.

Sources cited in this revision

No external citation was extracted for this revision. That is a statement about the source, not a claim that none exists.