Distributed Bragg reflector
A distributed Bragg reflector (DBR) is a reflector used in waveguides, such as optical fibers.
≈ 3 min read
Names in other languages
No names in other languages are held for this entry yet.
Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.
A distributed Bragg reflector (DBR) is a reflector used in waveguides, such as optical fibers. It is a structure formed from multiple layers of alternating materials with different refractive index, or by periodic variation of some characteristic (such as height) of a dielectric waveguide, resulting in periodic variation in the effective refractive index in the guide.
Each layer boundary causes a partial reflection and refraction of an optical wave. For waves whose vacuum wavelength is close to four times the optical thickness of the layers, the interaction between these beams generates constructive interference, and the layers act as a high-quality reflector. The range of wavelengths that are reflected is called the photonic stopband.
Within this range of wavelengths, light is "forbidden" to propagate in the structure.
Reflectivity
The DBR's reflectivity, R , for intensity is approximately given by R = \left[\frac{n_o (n_2)^{2N} - n_s(n_1)^{2N}}{n_o (n_2)^{2N} + n_s (n_1)^{2N}}\right]^2, where n_o,\ n_1,\ n_2 and n_s\, are the respective refractive indices of the originating medium, the two alternating materials, and the terminating medium (i.e. backing or substrate); and N is the number of repeated pairs of low/high refractive index material. This formula assumes the repeated pairs all have a quarter-wave thickness (that is n d = \lambda / 4 , where n is the refractive index of the layer, d is the thickness of the layer, and \lambda is the wavelength of the light).
The frequency bandwidth \Delta f_0 of the photonic stop-band can be calculated by \frac{\Delta f_0}{f_0} = \frac{4}{\pi}\arcsin\left(\frac{n_2 - n_1}{n_2 + n_1}\right), where f_o is the central frequency of the band. This configuration gives the largest possible ratio \frac{\Delta f_0}{f_0} that can be achieved with these two values of the refractive index.
Increasing the number of pairs in a DBR increases the mirror reflectivity and increasing the refractive index contrast between the materials in the Bragg pairs increases both the reflectivity and the bandwidth. A common choice of materials for the stack is titanium dioxide (n ≈ 2.5) and silica (n ≈ 1.5).
Substituting into the formula above gives a bandwidth of about 200 nm for 630 nm light. Distributed Bragg reflectors are critical components in vertical cavity surface emitting lasers and other types of narrow-linewidth laser diodes such as distributed feedback (DFB) lasers and distributed bragg reflector (DBR) lasers.
They are also used to form the cavity resonator (or optical cavity) in fiber lasers and free electron lasers.
Bio-inspired Bragg reflectors
Bio-inspired Bragg reflectors are 1D photonic crystals inspired by nature. Reflection of light from such a nanostructured matter results in structural colouration. When designed from mesoporous metal-oxides or polymers, these devices can be used as low-cost vapor/solvents sensors. For example, colour of this porous multi-layered structures will change when the matter filling up the pores is replaced by another, e.g., replacing air with water.
See also
Photonic crystal sensor
Text derived from https://en.wikipedia.org/w/index.php?oldid=1371261153 under CC BY-SA 4.0; modifications have been made.