{
  "id": "enwiki-001359620815",
  "slug": "double-data-rate",
  "title": "Double data rate",
  "qid": "",
  "lead": ". The dots are where data transfers take place, measured in millions of transfers per second (MT/s). In computing, double data rate (DDR) describes a computer bus that transfers data on both the rising and falling edges of the clock signal and hence doubles the memory bandwidth by transferring data twice per clock cycle. This is also known as double pumped, dual-pumped, and double transition. The term toggle mode is used in the context of NAND flash memory.",
  "body": ". The dots are where data transfers take place, measured in millions of transfers per second (MT/s).]] In computing, double data rate (DDR) describes a computer bus that transfers data on both the rising and falling edges of the clock signal and hence doubles the memory bandwidth by transferring data twice per clock cycle. This is also known as double pumped, dual-pumped, and double transition. The term toggle mode is used in the context of NAND flash memory. ==Overview== The simplest way to design a clocked electronic circuit is to make it perform one transfer per full cycle (rise and fall) of a clock signal. This, however, requires that the clock signal changes twice per transfer, while the data lines change at most once per transfer. When operating at a high bandwidth, signal integrity limitations constrain the clock frequency. By using both edges of the clock, the data signals operate with the same limiting frequency, thereby doubling the data transmission rate. This technique has been used for microprocessor front-side busses, Ultra-3 SCSI, expansion buses (AGP, PCI-X ), graphics memory (GDDR), main memory (both RDRAM and DDR1 through DDR5), and the HyperTransport bus on AMD's Athlon 64 processors. It is more recently being used for other systems with high data transfer speed requirements as an example, for the output of analog-to-digital converters (ADCs). DDR should not be confused with dual channel, in which each memory channel accesses two RAM modules simultaneously. The two technologies are independent of each other and many motherboards use both, by using DDR memory in a dual channel configuration. An alternative to double or quad pumping is to use self-clocking signals. This tactic was chosen by InfiniBand and PCI Express. Using the letter \"T\" for transfers is technically incorrect, as T is assigned by the International System of Units to the Tesla, a unit of magnetic flux density, so \"MT/s\" is a rate of change of magnetic field strength. However, given that such rapid magnetic field changes are confined to the specialized field of kicker magnet design, and such a magnet might switch a field in , a rate of = , the ambiguity is not a problem in practice. DDR SDRAM popularized the technique of referring to the bus bandwidth in megabytes per second, the product of the transfer rate and the bus width in bytes. DDR SDRAM operating with a 100&nbsp;MHz clock is called DDR-200 (after its 200&nbsp;MT/s data transfer rate), and a 64-bit (8-byte) wide DIMM operated at that data rate is called PC-1600, after its 1600&nbsp;MB/s peak (theoretical) bandwidth. Likewise, 12.8&nbsp;GB/s transfer rate DDR3-1600 is called PC3-12800. Some examples of popular designations of DDR modules: DDR SDRAM uses double-data-rate signaling only on the data lines. Address and control signals are still sent to the DRAM once per clock cycle (to be precise, on the rising edge of the clock), and timing parameters such as CAS latency are specified in clock cycles. Some less common DRAM interfaces, notably LPDDR2, GDDR5 and XDR DRAM, also send commands and addresses using double data rate. DDR5 uses two 7-bit double data rate command/address buses to each DIMM, where a registered clock driver chip converts to a 14-bit SDR bus to each memory chip.",
  "categories": [
    "22921019",
    "23118434",
    "23603337",
    "24745122",
    "27179408",
    "52641910",
    "68328988",
    "89324573"
  ],
  "license": "CC BY-SA 4.0",
  "source_uri": "https://en.wikipedia.org/w/index.php?oldid=1359620815",
  "content_hash": "",
  "created_at": null,
  "updated_at": 1781588172.0,
  "claims": [],
  "contradictions": [],
  "confidence": 0.6,
  "csl": {
    "id": "enwiki-001359620815",
    "type": "webpage",
    "title": "Double data rate",
    "author": [
      {
        "family": "Anticloud FZ LLE",
        "literal": "Anticloud FZ LLE"
      }
    ],
    "container-title": "encyclopegia.org",
    "publisher": "Anticloud FZ LLE",
    "publisher-place": "Dubai, United Arab Emirates",
    "URL": "https://encyclopegia.org/a/double-data-rate",
    "issued": {
      "date-parts": [
        [
          2026,
          11,
          16
        ]
      ]
    },
    "accessed": {
      "date-parts": [
        [
          2026,
          11,
          16
        ]
      ]
    },
    "license": "CC BY-SA 4.0",
    "DOI": "eo1:enwiki-001359620815",
    "isBasedOn": "https://en.wikipedia.org/w/index.php?oldid=1359620815",
    "note": "Immutable snapshot enwiki-001359620815"
  }
}