Envelope detector
≈ 2 min read
Names in other languages
No names in other languages are held for this entry yet.
Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.
An envelope detector (sometimes called a peak detector) is an electronic circuit that takes a (relatively) high-frequency signal as input and outputs the envelope of the original signal.
An envelope detector (sometimes called a peak detector) is an electronic circuit that takes a (relatively) high-frequency signal as input and outputs the envelope of the original signal. The output is connected to a capacitor of value C and resistor of value R in parallel to ground. The capacitor is charged as the input voltage approaches its positive peaks. At other times, the capacitor is gradually discharged through the resistor.
The resistor and capacitor form a 1st-order low pass filter, which attenuates higher frequencies at a rate of -6 dB per octave above its cutoff frequency of \tfrac{1}{2 \pi R C} . The filter's RC time constant (\tau {=} R C) must be small enough to track quickly-falling envelope slopes and "top up" the envelope's voltage every peak to prevent negative peak clipping. \frac{1}{f_\text{carrier}} \ll \tau \ll \frac{1}{f_\text{max}} \; .
Next, to filter out the DC component, the output could pass through a simple high-pass filter, such as a DC-blocking capacitor. x(t) = R(t) \cos ( \omega t + \varphi(t) ) \, In the case of AM, φ(t) (the phase component of the signal) is constant and can be ignored. In AM, the carrier frequency \omega is also constant. Thus, all the information in the AM signal is in R(t). R(t) is called the envelope of the signal.
Hence an AM signal is given by the function x(t) = (C + m(t)) \cos(\omega t) \, with m(t) representing the original audio frequency message, C the carrier amplitude and R(t) equal to C + m(t). So, if the envelope of the AM signal can be extracted, the original message can be recovered. In the case of FM, the transmitted x(t) has a constant envelope R(t) = R and can be ignored. However, many FM receivers measure the envelope anyway for received signal strength indication.
Text derived from https://en.wikipedia.org/w/index.php?oldid=1346187697 under CC BY-SA 4.0; modifications have been made.