Explorer 31

Uses your system voice; voice and rate in settings.

Snapshot

≈ 5 min read

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

Explorer 31, also called DME-A, was a NASA satellite launched as part of the Explorer program. Explorer 31 was launched on 29 November 1965 from Vandenberg Air Force Base, California, with a Thor-Agena launch vehicle. Explorer 31 was released along with the Canadian satellite Alouette 2. Explorer 31 was a small ionospheric observatory instrumented to make direct measurements of selected ionospheric parameters at the spacecraft. Since the spacecraft had no tape recorder, data could be observed at the spacecraft only when the spacecraft was in sight of the telemetry station and when commanded on. Experiments were operated either simultaneously or sequentially, as desired. The satellite was spin-stabilized with the spin axis perpendicular to the orbit plane. The spin rate and spin axis were controlled by an onboard magnetic torquing system. The attitude and spin rate information were observed by a Sun sensor and a three-axis magnetometer. Satellite performance was satisfactory except for a partial power failure in May 1966, which reduced data acquisition time to about half the nominal amount. Some difficulties were encountered in obtaining attitude information that was necessary for the reduction of the experiment observations. On July 1, 1969, the satellite data observations were terminated with five of the seven experiments operating.…

Explorer 31, also called DME-A, was a NASA satellite launched as part of the Explorer program. Explorer 31 was launched on 29 November 1965 from Vandenberg Air Force Base, California, with a Thor-Agena launch vehicle. Explorer 31 was released along with the Canadian satellite Alouette 2. Explorer 31 was a small ionospheric observatory instrumented to make direct measurements of selected ionospheric parameters at the spacecraft. Since the spacecraft had no tape recorder, data could be observed at the spacecraft only when the spacecraft was in sight of the telemetry station and when commanded on. Experiments were operated either simultaneously or sequentially, as desired. The satellite was spin-stabilized with the spin axis perpendicular to the orbit plane. The spin rate and spin axis were controlled by an onboard magnetic torquing system. The attitude and spin rate information were observed by a Sun sensor and a three-axis magnetometer. Satellite performance was satisfactory except for a partial power failure in May 1966, which reduced data acquisition time to about half the nominal amount. Some difficulties were encountered in obtaining attitude information that was necessary for the reduction of the experiment observations. On July 1, 1969, the satellite data observations were terminated with five of the seven experiments operating. Responsibility for standby monitoring of the satellite was given to the ESSA telemetry station at Boulder, Colorado, on July 8, 1969. During this standby operation, experiment data were collected only once on 1 October 1969, for 9 minutes from the electrostatic probe for use in studying a red arc event. On January 15, 1971, no response was received from a variety of satellite commands, and the satellite was abandoned. The spherical ion mass spectrometer probe was used to investigate the composition of positive ions at altitudes between and . The instrument consisted of a diameter ion collector, circumscribed by a diameter nickel grid that was approximately 40% transparent. The grid had a 6-volts bias to prevent electrons from reaching the collector. The probe rested on top of a -long rod mounted along the satellite spin axis. In addition to the principal bias-potential sweep, two small ac potentials were applied to the collector. The amplitude and depth of modulation of the resulting carrier current were then measured as a function of probe potential. This "retarding potential" ion spectrometer had low resolution. Hydrogen, with a mass-to-charge ratio (M/Q) of 1, was readily distinguished from atomic oxygen ions (M/Q = 16). However, atomic nitrogen ions (M/Q = 14) could not be distinguished from atomic oxygen ions. The signal current to the probe varied inversely with ionic mass, and consequently, the instrument was less sensitive to heavy masses. When the concentration of atomic oxygen ions was significantly greater than 300 ions per cc, accurate temperature measurements could be made for the atomic oxygen ions.

Text derived from https://en.wikipedia.org/w/index.php?oldid=1185403473 under CC BY-SA 4.0; modifications have been made.

Sources cited in this revision

9 named source(s) extracted from the cited revision. A source with no author is shown by its publication; nothing is invented.