Lesson plan

Fan disk

A fan disk is the central hub of a fan in a turbofan engine. Fan blades are attached to the fan disk, which is rotated by a shaft driven by a gas turbine. In modern passenger aircraft, most of the propulsive thrust comes from fans, which are driven by gas turbines. A single stage fan was developed to produce high thrust and act as a multi-bladed propeller. Fan disks are attached to a shaft that is driven by a multistage Low Pressure Turbine (LPT) to reduce mechanical stress. Air enters the front of an engine, where a fan increases the pressure by rotating within a duct. Most of the pressurized air is exhausted through the rear of the engine, where it expands and its velocity increases. Fan disks are large and heavy. The one shown in the photo is over 31 inches (1.2 m) in diameter, and rotates up to 3800 rotations per minute (RPM). Fan disks must withstand the centrifugal force of the attached fan blades. Because of their size and weight, a failed fan disk can severely damage an aircraft, as happened with United Airlines Flight 232 in 1989. While operating there is increased aerodynamic loading on the fan disk while the fan blade tips are traveling faster than sound. A fan blade weighing 15-lbs can experience upwards of 60 tons of centrifugal force. Fan disks are usually made of a titanium alloy, which is strong, light weight, and resistant to corrosion.

Back to article

Article summary

A fan disk is the central hub of a fan in a turbofan engine. Fan blades are attached to the fan disk, which is rotated by a shaft driven by a gas turbine. In modern passenger aircraft, most of the propulsive thrust comes from fans, which are driven by gas turbines. A single stage fan was developed to produce high thrust and act as a multi-bladed propeller. Fan disks are attached to a shaft that is driven by a multistage Low Pressure Turbine (LPT) to reduce mechanical stress. Air enters the front of an engine, where a fan increases the pressure by rotating within a duct. Most of the pressurized air is exhausted through the rear of the engine, where it expands and its velocity increases. Fan disks are large and heavy. The one shown in the photo is over 31 inches (1.2 m) in diameter, and rotates up to 3800 rotations per minute (RPM). Fan disks must withstand the centrifugal force of the attached fan blades. Because of their size and weight, a failed fan disk can severely damage an aircraft, as happened with United Airlines Flight 232 in 1989. While operating there is increased aerodynamic loading on the fan disk while the fan blade tips are traveling faster than sound. A fan blade weighing 15-lbs can experience upwards of 60 tons of centrifugal force. Fan disks are usually made of a titanium alloy, which is strong, light weight, and resistant to corrosion.

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.