Lesson plan
HYPERchannel
HYPERchannel, sometimes rendered Hyperchannel, was a local area networking system for mainframe computers, especially supercomputers, introduced by Network Systems Corporation in the 1970s. It ran at the then-fast speed of 50 Mbits/second, performance that would not be matched by commodity hardware until the introduction of Fast Ethernet in 1995. HYPERchannel ran over very thick coax cable or fibre optic extensions and required adaptor hardware the size of a minicomputer. The networking protocol was entirely proprietary. Solutions for Control Data, IBM, UNISYS, and Cray computers were their primary products, but a wide variety of support emerged in the 1980s, including DEC VAX, and similar superminicomputers. The introduction of 10 mbit/sec Ethernet in the 1980s was a major problem for the HYPERchannel product, one the company never clearly addressed. The company introduced products to allow HYPERchannel protocols to travel over Ethernet, and systems that allowed Ethernet-equipped computers to connect to HYPERchannel systems, as well as TCP/IP and other standard protocol support. However, these generally had the side-effect of further eroding the need for the product, other than raw performance, and it found itself pressed into an ever smaller niche that was eventually killed off by new systems with dramatically higher performance.
Article summary
HYPERchannel, sometimes rendered Hyperchannel, was a local area networking system for mainframe computers, especially supercomputers, introduced by Network Systems Corporation in the 1970s. It ran at the then-fast speed of 50 Mbits/second, performance that would not be matched by commodity hardware until the introduction of Fast Ethernet in 1995. HYPERchannel ran over very thick coax cable or fibre optic extensions and required adaptor hardware the size of a minicomputer. The networking protocol was entirely proprietary. Solutions for Control Data, IBM, UNISYS, and Cray computers were their primary products, but a wide variety of support emerged in the 1980s, including DEC VAX, and similar superminicomputers. The introduction of 10 mbit/sec Ethernet in the 1980s was a major problem for the HYPERchannel product, one the company never clearly addressed. The company introduced products to allow HYPERchannel protocols to travel over Ethernet, and systems that allowed Ethernet-equipped computers to connect to HYPERchannel systems, as well as TCP/IP and other standard protocol support. However, these generally had the side-effect of further eroding the need for the product, other than raw performance, and it found itself pressed into an ever smaller niche that was eventually killed off by new systems with dramatically higher performance.
Key claims
No claims recorded.
Discussion questions
- Summarise the article in your own words. Which single claim would you verify first, and why?
- Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
- If two sources disagreed about one of these facts, what would you need in order to trust one over the other?
Bibliography
No sources recorded.
Key claims and bibliography are generated from the same tracked claims and sources as the article page.