Interrupt handler

Article summary

In computer systems programming, an interrupt handler, also known as an interrupt service routine (ISR), is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions, and are used for implementing device drivers or transitions between protected modes of operation, such as system calls. The traditional form of interrupt handler is the hardware interrupt handler. Hardware interrupts arise from an electrical trigger. The specifics of how an interrupt is handled depends on the hardware, but generally the CPU pauses execution of its current task, saves current program counter (and often flags) to the stack, and updates its program counter to the address of the routine that is responsible for servicing the interrupt. The interrupt service routine must then save any registers it may change. In general, hardware interrupts and their handlers are used to handle high-priority conditions that require the interruption of the current code the processor is executing. It is convenient for software to be able to trigger the same mechanism: a software interrupt. Rather than using a hard-coded interrupt dispatch table at the hardware level, software interrupts are often implemented at the operating system level as a form of callback function.…

Key claims

No claims recorded.

Discussion questions

1. Summarise the article in your own words. Which single claim would you verify first, and why?
2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.