Lesson plan
IQRF
IQRF is a technology for wireless packet-oriented communication via radio frequency (RF) in sub-GHz ISM bands. It is intended for general use where wireless connectivity is needed, either point-to-point or in complex networks, e.g. for telemetry, industrial control, automation of buildings and cities and Internet of Things. Fully open functionality depends solely on a user-specific application. Basic IQRF communication device is a transceiver module (TR) including MCU with built-in operating system (OS) implementing link layer and network layer supporting Mesh networking utilizing IQMESH protocol. The application software can be written directly under OS in C language. Unlike the solution stack used, e.g. by Zigbee, only the application program is compiled while in development. Higher communication level (transport layer) is DPA. It is an optional open protocol and framework enabling control by sending commands and receiving responses via standard wired interface (UART or SPI) or via RF. DPA is implemented as a ready-to-use software plug-in called hardware profile (HWP) to be uploaded into the transceiver. Then no programming is needed. However, it is possible to modify the existing HWP functionality by a user-specific Custom DPA handler programmed in C. The transceivers supporting DPA are called DCTR (data controlled transceivers).…
Article summary
IQRF is a technology for wireless packet-oriented communication via radio frequency (RF) in sub-GHz ISM bands. It is intended for general use where wireless connectivity is needed, either point-to-point or in complex networks, e.g. for telemetry, industrial control, automation of buildings and cities and Internet of Things. Fully open functionality depends solely on a user-specific application. Basic IQRF communication device is a transceiver module (TR) including MCU with built-in operating system (OS) implementing link layer and network layer supporting Mesh networking utilizing IQMESH protocol. The application software can be written directly under OS in C language. Unlike the solution stack used, e.g. by Zigbee, only the application program is compiled while in development. Higher communication level (transport layer) is DPA. It is an optional open protocol and framework enabling control by sending commands and receiving responses via standard wired interface (UART or SPI) or via RF. DPA is implemented as a ready-to-use software plug-in called hardware profile (HWP) to be uploaded into the transceiver. Then no programming is needed. However, it is possible to modify the existing HWP functionality by a user-specific Custom DPA handler programmed in C. The transceivers supporting DPA are called DCTR (data controlled transceivers).…
Key claims
No claims recorded.
Discussion questions
- Summarise the article in your own words. Which single claim would you verify first, and why?
- Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
- If two sources disagreed about one of these facts, what would you need in order to trust one over the other?
Bibliography
No sources recorded.
Key claims and bibliography are generated from the same tracked claims and sources as the article page.