Lock (water navigation)
at Marsworth in Buckinghamshire, England at Heidelberg in Germany lock near Yichang on the Yangtze river, China A lock is a device used for raising and lowering boats, ships and other watercraft between stretches of water of different…
≈ 15 min read
Names in other languages
No names in other languages are held for this entry yet.
Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.
at Marsworth in Buckinghamshire, England at Heidelberg in Germany lock near Yichang on the Yangtze river, China A lock is a device used for raising and lowering boats, ships and other watercraft between stretches of water of different levels on river and canal waterways. The distinguishing feature of a lock is a chamber in a permanently fixed position in which the water level can be varied.
In a caisson lock, a boat lift, or on a canal inclined plane, it is the chamber itself (usually then called a caisson) that rises and falls. Locks are used to make a river more easily navigable, or to allow a canal to cross land that is not level. Over time, more and larger locks have been used in canals to allow a more direct route to be taken.
Ancient Egypt
In ancient Egypt, river locks were probably part of the Canal of the Pharaohs. Engineers of Ptolemy II are credited by Diodorus Siculus with being the first to solve the problem of keeping the Nile free of salt water when they invented the lock around 274–273 BC.
Basic operation
. The gates in each pair close against each other at an 18° angle to approximate an arch against the water pressure on the "upstream" side of the gates when the water level on the "downstream" side is lower. All pound locks have three elements: A watertight chamber connecting the upper and lower canals, and large enough to enclose one or more boats.
The position of the chamber is fixed, but its water level can vary. A gate (often a pair of "pointing" half-gates) at each end of the chamber. A gate is opened to allow a boat to enter or leave the chamber; when closed, the gate is watertight.
A set of lock gear to empty or fill the chamber as required. This is usually a simple valve (traditionally, a flat panel (paddle) lifted by manually winding a rack and pinion mechanism) which allows water to drain into or out of the chamber. Larger locks may use pumps.
The principle of operating a lock is simple. For a boat travelling downstream, the process is: If the water in the chamber is low, the boat waits while the chamber is filled by the upstream valve. The upstream gates are opened and the boat moves in.
The upstream gates are closed. The chamber is drained through the downstream valve until the water level matches the downstream water level. The downstream gates are opened and the boat moves out.
For a boat travelling upstream, the process is reversed. The whole operation will usually take between 10 and 20 minutes, depending on the size of the lock and whether the water in the lock chamber was at the boat's level or the other level when it arrived at the lock.
Boaters approaching a lock are usually pleased to meet another boat coming towards them, because this boat will have just exited the lock on their level and therefore set the lock in their favour – saving about 5 to 10 minutes. However, this is not true for staircase locks, where it is quicker for boats to go through in convoy, and it also uses less water.
Basic pound lock
Canal at Äänekoski in Central Finland A pound lock is most commonly used on canals and rivers today. A pound lock has a chamber (a pound) with gates at both ends that control the level of water in the pound. In contrast, an earlier design with a single gate was known as a flash lock.
Pound locks were first used in China during the Song dynasty (960–1279 CE), having been pioneered by the Song politician and naval engineer Qiao Weiyue in 984. They replaced earlier double slipways that had caused trouble and are mentioned by the Chinese polymath Shen Kuo (1031–1095) in his book Dream Pool Essays (published in 10881), and fully described in the Chinese historical text Song Shi (compiled in 1345): The distance between the two locks was rather more than 50 paces, and the whole space was covered with a great roof like a shed.
The gates were 'hanging gates'; when they were closed the water accumulated like a tide until the required level was reached, and then when the time came it was allowed to flow out. The water level could differ by at each lock and in the Grand Canal the level was raised in this way by .
Diagonal lock
This is similar to a shaft lock, but having the shaft built on an incline. Boats are moored to floating bollards which guide them along the shaft as it fills or empties. The Diagonal Lock Advisory Group has identified several sites in Britain where the new design could be installed, either on new waterways or canals under restoration.
Projects under consideration include the restoration of the Lancaster Canal to Kendal and the proposed new branch of the Grand Union Canal between Bedford and Milton Keynes.
Drop locks
drop lock A drop lock can consist of two conventional lock chambers leading to a sump pound, or a single long chamber incorporating the sump – although the term properly applies only to the second case. As the pounds at either end of the structure are at the same height, the lock can only be emptied either by allowing water to run to waste from the sump to a lower stream or drain, or (less wastefully) by pumping water back up to the canal.
Particularly in the two-chamber type, there would be a need for a bypass culvert, to allow water to move along the interrupted pound and so supply locks further down the canal. In the case of the single-chamber type, this can be achieved by keeping the lock full and leaving the gates open while not in use.
While the concept has been suggested in a number of cases, the only example in the world of a drop lock that has actually been constructed is at Dalmuir on the Forth and Clyde Canal in Scotland. This lock, of the single-chamber type, was incorporated during the restoration of the canal, to allow the replacement of a swing bridge (on a busy A road) by a fixed bridge, and so answer criticisms that the restoration of the canal would cause frequent interruptions of the heavy road traffic.
It can be emptied by pumping – but as this uses a lot of electricity the method used when water supplies are adequate is to drain the lock to a nearby burn.
Round locks on intersecting canals
The best known example of a round lock is the Agde Round Lock on the Canal du Midi in France. This serves as a lock on the main line of the canal and allows access to the Hérault River. A second French round lock can be found in the form of the now-disused Écluse des Lorraines, connecting the Canal latéral à la Loire with the River Allier.
Lock flights
on the Kennet and Avon Canal Loosely, a flight of locks is simply a series of locks in close-enough proximity to be identified as a single group. For many reasons, a flight of locks is preferable to the same number of locks spread more widely: crews are put ashore and picked up once, rather than multiple times; transition involves a concentrated burst of effort, rather than a continually interrupted journey; a lock keeper may be stationed to help crews through the flight quickly; and where water is in short supply, a single pump can recycle water to the top of the whole flight.
The need for a flight may be determined purely by the lie of the land, but it is possible to group locks purposely into flights by using cuttings or embankments to "postpone" the height change. Examples: Caen Hill locks, Devizes. "Flight" is not synonymous with "staircase" (see below).
A set of locks is only a staircase if successive lock chambers share a gate (i.e. do not have separate top and bottom gates with a pound between them). Most flights are not staircases, because each chamber is a separate lock (with its own upper and lower gates), there is a navigable pound (however short) between each pair of locks, and the locks are operated in the conventional way.
However, some flights include (or consist entirely of) staircases. On the Grand Union (Leicester) Canal, the Watford flight consists of a four-chamber staircase and three separate locks; and the Foxton flight consists entirely of two adjacent 5-chamber staircases.
Staircase locks
, England Where a very steep gradient has to be climbed, a lock staircase is used. There are two types of staircase, "real" and "apparent". A "real" staircase can be thought of as a "compressed" flight, where the intermediate pounds have disappeared, and the upper gate of one lock is also the lower gate of the one above it.
However, it is incorrect to use the terms staircase and flight interchangeably: because of the absence of intermediate pounds, operating a staircase is very different from operating a flight. It can be more useful to think of a staircase as a single lock with intermediate levels (the top gate is a normal top gate, and the intermediate gates are all as tall as the bottom gate).
As there is no intermediate pound, a chamber can only be filled by emptying the one above, or emptied by filling the one below: thus the whole staircase has to be full of water (except for the bottom chamber) before a boat starts to ascend, or empty (except for the top chamber) before a boat starts to descend. In an "apparent" staircase the chambers still have common gates, but the water does not pass directly from one chamber to the next, going instead via side ponds.
This means it is not necessary to ensure that the flight is full or empty before starting. Examples of famous "real" staircases in England are Bingley and Grindley Brook.
Two-rise staircases are more common: Snakeholme Lock and Struncheon Hill Lock on the Driffield Navigation were converted to staircase locks after low water levels hindered navigation over the bottom cill at all but the higher tides – the new bottom chamber rises just far enough to get the boat over the original lock cill. In China, the recently completed Three Gorges Dam includes a double five-step staircase for large ships, and a ship lift for vessels of less than 3000 metric tons.
Examples of "apparent" staircases are Foxton Locks and Watford Locks on the Leicester Branch of the Grand Union. Operation of a staircase is more involved than a flight. Inexperienced boaters may find operating staircase locks difficult.
Key concerns are either sending down more water than the lower chambers can cope with (flooding the towpath, or sending a wave along the canal) or completely emptying an intermediate chamber (although this shows that a staircase lock can be used as an emergency dry dock). To avoid these mishaps, it is usual to have the whole staircase empty before starting to descend, or full before starting to ascend, apart from the initial chamber.
One difference in using a staircase of either type (compared with a single lock, or a flight) is the optimal sequence for letting boats through. In a single lock (or a flight with room for boats to pass) boats should ideally alternate in direction. In a staircase, however, it is quicker for a boat to follow a previous one going in the same direction.
Partly for this reason staircase locks such as Grindley Brook, Foxton, Watford and Bratch are supervised by lockkeepers, at least during the main cruising season, in which keepers try to alternate as many boats up, followed by down as there are chambers in the flight. As with a flight, it is possible on a broad canal for more than one boat to be in a staircase at the same time, but managing this without waste of water requires expertise.
On English canals, a staircase of more than two chambers is usually staffed: the lockkeepers at Bingley (looking after both the "5-rise" and the "3-rise") ensure that there are no untoward events and that boats are moved through as speedily and efficiently as possible. Such expertise permits unusual feats, such as boats travelling in opposite directions can pass each other halfway up the staircase by moving sideways around each other; or at peak times, one can have all the chambers full simultaneously with boats travelling in the same direction.
Stop locks
When variable conditions meant that a higher water level in the new canal could not be guaranteed, then the older company would also build a stop lock (under its own control, with gates pointing towards its own canal) which could be closed when the new canal was low. This resulted in a sequential pair of locks, with gates pointing in opposite directions: one example was at Hall Green near Kidsgrove, where the southern terminus of the Macclesfield Canal joined the Hall Green Branch of the earlier Trent and Mersey Canal.
The four-gate stop lock near Kings Norton Junction, between the Stratford-upon-Avon Canal and the Worcester and Birmingham Canal, was replaced in 1914 by a pair of guillotine lock gates which stopped the water flow regardless of which canal was higher. These gates have been permanently open since nationalisation.
Tidal locks
at Lock and Dam No. 6
Largest locks
The size of locks cannot be compared without considering the difference in water level that they are designed to operate under. For example, the Bollène lock on the River Rhône has a fall of at least , the Leerstetten, Eckersmühlen and Hilpoltstein locks on the Rhine–Main–Danube Canal have a fall of , each and the Oskemen Lock on the Irtysh River in Kazakhstan has a drop of .
In 2016, the Kieldrecht Lock in the Port of Antwerp in Belgium took over the title of the world's largest lock from the Berendrecht Lock in the same port and still has the title for largest volume. In 2022, the IJmuiden sea lock serving the Port of Amsterdam became the world's largest lock by surface area. The lock is long, wide and has sliding lock gates creating a usable depth of .
File:Lock in the Hatton Locks.jpg|A gate in the Hatton flight in England File:Iroquois Lock (2005).jpg|Iroquois Lock on the Saint Lawrence Seaway File:Replica sluis in Botterbeek P3260262.JPG|Model of early river pound lock, constructed in Lankheet water park, Netherlands. File:Monkey-Marsh-lock-by-John-Lloyd.jpg|The turf-sided Monkey Marsh Lock on the Kennet & Avon Canal at Thatcham.
File:Canal Saint-Denis-Ecluse N°1-Le petit bief.JPG|The cill exposed in the deep Pont de Flandre lock on the Canal Saint-Denis, Paris. File:Eynsham Lock - geograph.org.uk - 5594146.jpg|The balance beams typical of many locks on the Upper Thames at Eynsham Lock, Eynsham, Oxfordshire, England. Visible on the gates are the paddle winding gears, used to operate the sluice gates.
File:JesusGreenLock-Cambridge.jpg|Top gates of Jesus Lock, a beam lock on the River Cam in Cambridge, England. File:ZSchützmechanik.jpg|200-year-old paddle gear on the Wiener Neustädter Kanal, Austria File:BCN water conservation lock.jpg|Water conservation gear on the Birmingham Canal Navigations File:Lock gate cogs, Montgomery Canal - geograph.org.uk - 1806427.jpg|Lock gate controls on a canal File:Caversham Lock - geograph.org.uk - 5907080.jpg|Caversham Lock on the River Thames, with its chamber nearly filled.
Visible on top of the gates are the hydraulic mechanisms that raise and lower the sluices in their raised position. To the right is one of two pedestals which are used to operate the gates and sluices, as well as the lock cottage.
See also
Canal Canal safety gates Channel (geography) Canal & River Trust Water resources List of waterways List of canals by country Canals of Amsterdam Canals of the United Kingdom Hydraulics Hydraulic engineering Control lock Sluice Watermill Water slope
External links
Deepest Canal Locks in England Interactive simulation of lock operation – this demonstration shows guillotine-type gates for clarity for students with single and double flight locks and lesson plans Video footage of the unique Drop Lock at Dalmuir on the Forth & Clyde Canal
Text derived from https://en.wikipedia.org/w/index.php?oldid=1376658402 under CC BY-SA 4.0; modifications have been made.
References
- ↩Wikipedia “Lock (water navigation)” publication date (×1) · confidence 0.95 revision URL