Lesson plan

M1 link

The M1 link was the U.S. military designation for a steel disintegrating link designed for the M1917 Browning machine gun and M1919 Browning machine gun, and the .30-06 Springfield cartridge that they fired. A single round would hold two links together, and more could be added to make up a belt of any quantity of rounds, though for the mounted machine guns of the time, a belt of 250 rounds was most commonly used. As was the trend with American belt-fed firearms, as opposed to Soviet designs, belts of ammunition feed into the gun from the left side to the right. The left side of a single link had a circular loop which would hold the main body of the cartridge case, and an extension on the right that formed two similar loops which was designed to fit in between the two right-side loops of the next link. The rear loop of the right side of the link would hold onto the cartridge case just below the shoulder, as would the left side loop, where the front loop of the left side of the link held onto the cartridge neck, and was therefore a bit smaller in diameter. This was designed so that the M1919 machine gun's extractor claw would take hold of the rim of the cartridge and pull it out of the linked belt from the rear, where it would then be fed into the chamber and would rest there until fired.…

Back to article

Article summary

The M1 link was the U.S. military designation for a steel disintegrating link designed for the M1917 Browning machine gun and M1919 Browning machine gun, and the .30-06 Springfield cartridge that they fired. A single round would hold two links together, and more could be added to make up a belt of any quantity of rounds, though for the mounted machine guns of the time, a belt of 250 rounds was most commonly used. As was the trend with American belt-fed firearms, as opposed to Soviet designs, belts of ammunition feed into the gun from the left side to the right. The left side of a single link had a circular loop which would hold the main body of the cartridge case, and an extension on the right that formed two similar loops which was designed to fit in between the two right-side loops of the next link. The rear loop of the right side of the link would hold onto the cartridge case just below the shoulder, as would the left side loop, where the front loop of the left side of the link held onto the cartridge neck, and was therefore a bit smaller in diameter. This was designed so that the M1919 machine gun's extractor claw would take hold of the rim of the cartridge and pull it out of the linked belt from the rear, where it would then be fed into the chamber and would rest there until fired.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.