Moore's law

of transistor counts for microprocessors against dates of introduction, nearly doubling every two years |alt=refer to caption Moore's law is the observation that the number of transistors in an integrated circuit (IC) doubles about every…

Uses your system voice; voice and rate in settings.

≈ 12 min read

Cite, export and learn8 citation formats · 8 exports · lesson and quiz

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

of transistor counts for microprocessors against dates of introduction, nearly doubling every two years |alt=refer to caption Moore's law is the observation that the number of transistors in an integrated circuit (IC) doubles about every two years, with minimal increase in cost. Despite the name, Moore's law describes an empirical relationship, not a scientific law.

This type of observation, an experience curve effect, quantifies efficiency gains from learned experience in production. The observation is named after Gordon Moore, the co-founder of Fairchild Semiconductor and Intel and former Chief Executive Officer of the latter, who in 1965 noted that the number of components per integrated circuit had been doubling every year, and projected that this rate of growth would continue for at least another decade.

In 1975, looking forward to the next decade, he revised the forecast to doubling every two years, a compound annual growth rate (CAGR) of 41%. Moore's empirical evidence did not imply that the historical trend would continue; nevertheless, his prediction has held since 1975 and has since become known as a law.

Moore's prediction has been used in the semiconductor industry to guide long-term planning and to set targets for research and development (R&D). Advancements in digital electronics, such as the reduction in quality-adjusted prices of microprocessors, the increase in memory capacity (RAM and flash), the improvement of sensors, and even the number and size of pixels in digital cameras, are strongly linked to Moore's law. These ongoing changes in digital electronics have been a driving force of technological and social change, productivity, and economic growth.

Industry experts have not reached a consensus on exactly when Moore's law will cease to apply. Microprocessor architects report that semiconductor advancement has slowed industry-wide since around 2010, slightly below the pace predicted by Moore's law.

In September 2022, Nvidia CEO Jensen Huang considered Moore's law dead, while Intel's then-CEO Pat Gelsinger had the opposite view. portable computer, with a 4 MHz 8-bit Zilog Z80 CPU, and a 2007 Apple iPhone with a 412 MHz 32-bit ARM11 CPU; the Executive has 100 times the weight, almost 500 times the volume, approximately 10 times the inflation-adjusted cost, and 1/100th the clock frequency of the smartphone.|alt=Large early portable computer next to a modern smartphone Microprocessor architects report that since around 2010, semiconductor advancement has slowed industry-wide below the pace predicted by Moore's law. Brian Krzanich, the former CEO of Intel, cited Moore's 1975 revision as a precedent for the current deceleration, which results from technical challenges and is "a natural part of the history of Moore's law".

The rate of improvement in physical dimensions known as Dennard scaling also ended in the mid-2000s. As a result, much of the semiconductor industry has shifted its focus to the needs of major computing applications rather than semiconductor scaling.

Nevertheless, as of 2019, leading semiconductor manufacturers TSMC and Samsung Electronics claimed to keep pace with Moore's law with 10, 7, and 5 nm nodes in mass production. for NAND flash memory allows the doubling of floating-gate MOSFET components manufactured in the same wafer area in less than 18 months.|alt=A semi-log plot of NAND flash design rule dimensions in nanometers against dates of introduction. The downward linear regression indicates an exponential decrease in feature dimensions over time.

Numerous innovations by scientists and engineers have sustained Moore's law since the beginning of the IC era. Some of the key innovations are listed below, as examples of breakthroughs that have advanced integrated circuit and semiconductor device fabrication technology, allowing transistor counts to grow by more than seven orders of magnitude in less than five decades.

Integrated circuit (IC): The raison d'être for Moore's law. The germanium hybrid IC was invented by Jack Kilby at Texas Instruments in 1958, followed by the invention of the silicon monolithic IC chip by Robert Noyce at Fairchild Semiconductor in 1959.

Complementary metal–oxide–semiconductor (CMOS): The CMOS process was invented by Chih-Tang Sah and Frank Wanlass at Fairchild Semiconductor in 1963. Dynamic random-access memory (DRAM): DRAM was developed by Robert H. Dennard at IBM in 1967.

Chemically amplified photoresist: Invented by Hiroshi Ito, C. Grant Willson and J. M. J. Fréchet at IBM circa 1980, which was 5–10 times more sensitive to ultraviolet light. IBM introduced chemically amplified photoresist for DRAM production in the mid-1980s. Deep UV excimer laser photolithography: Invented by Kanti Jain at IBM circa 1980.

Prior to this, excimer lasers had been mainly used as research devices since their development in the 1970s. From a broader scientific perspective, the invention of excimer laser lithography has been highlighted as one of the major milestones in the 50-year history of the laser.

Interconnect innovations: Interconnect innovations of the late 1990s, including chemical-mechanical polishing or chemical mechanical planarization (CMP), trench isolation, and copper interconnects—although not directly a factor in creating smaller transistors—have enabled improved wafer yield, additional layers of metal wires, closer spacing of devices, and lower electrical resistance. Computer industry technology roadmaps predicted in 2001 that Moore's law would continue for several generations of semiconductor chips.

MOSFET. The threshold voltage is around 0.45 V. Nanowire MOSFETs lie toward the end of the ITRS roadmap for scaling devices below 10 nm gate lengths.|alt=animated plot showing electron density and current as gate voltage varies One of the key technical challenges of engineering future nanoscale transistors is the design of gates.

As device dimensions shrink, controlling the current flow in the thin channel becomes more difficult. Modern nanoscale transistors typically take the form of multi-gate MOSFETs, with the FinFET being the most common nanoscale transistor. The FinFET has gate dielectric on three sides of the channel.

In comparison, the gate-all-around MOSFET (GAAFET) structure has even better gate control. A gate-all-around MOSFET (GAAFET) was first demonstrated in 1988 by a Toshiba research team led by Fujio Masuoka, who demonstrated a vertical nanowire GAAFET that he called a surrounding gate transistor (SGT). Masuoka, best known as the inventor of flash memory, later left Toshiba and founded Unisantis Electronics in 20041 to research surrounding-gate technology along with Tohoku University.

In 2006, a team of Korean researchers from the Korea Advanced Institute of Science and Technology (KAIST) and the National Nano Fab Center developed a 3 nm transistor, the world's smallest nanoelectronic device at the time, based on FinFET technology. In 2010, researchers at the Tyndall National Institute in Cork, Ireland announced a junctionless transistor.

A control gate wrapped around a silicon nanowire can control the passage of electrons without the use of junctions or doping. They claim these may be produced at 10 nm scale using existing fabrication techniques. In 2011, researchers at the University of Pittsburgh announced the development of a single-electron transistor, 1.5 nm in diameter, made out of oxide-based materials.

Three wires converge on a central island that can house one or two electrons. Electrons tunnel from one wire to another through the island. Conditions on the third wire result in distinct conductive properties, including the ability of the transistor to act as a solid-state memory.

Nanowire transistors could spur the creation of microscopic computers. In 2012, a research team at the University of New South Wales announced the development of the first working transistor consisting of a single atom placed precisely in a silicon crystal (not just picked from a large sample of random transistors).

Moore's law predicted this milestone to be reached for ICs in the lab by 2020. In 2015, IBM demonstrated 7 nm node chips with silicon–germanium transistors produced using EUVL. The company believed this transistor density would be four times that of the then-current 14 nm chips.

Samsung and TSMC plan to manufacture 3 nm GAAFET nodes by 2021 2022. Note that node names, such as 3 nm, have no relation to the physical size of device elements (transistors). A Toshiba research team including T. Imoto, M. Matsui and C. Takubo developed a system block module wafer bonding process for manufacturing three-dimensional integrated circuit (3D IC) packages in 2001.

In April 2007, Toshiba introduced an eight-layer 3D IC, the 16 GB THGAM embedded NAND flash memory chip that was manufactured with eight stacked 2 GB NAND flash chips. In September 2007, Hynix introduced 24-layer 3D IC, a 16 GB flash memory chip that was manufactured with 24 stacked NAND flash chips using a wafer bonding process.

V-NAND, also known as 3D NAND, allows flash memory cells to be stacked vertically using charge trap flash technology originally presented by John Szedon in 1967, significantly increasing the number of transistors on a flash memory chip. 3D NAND was first announced by Toshiba in 2007. V-NAND was first commercially manufactured by Samsung Electronics in 2013.

In 2008, researchers at HP Labs announced a working memristor, a fourth basic passive circuit element whose existence only had been theorized previously. The memristor's unique properties permit the creation of smaller and better-performing electronic devices. In 2014, bioengineers at Stanford University developed a circuit modeled on the human brain.

Sixteen Neurocore chips simulate one million neurons and billions of synaptic connections, claimed to be times faster as well as more energy efficient than a typical PC. In 2015, Intel and Micron announced 3D XPoint, a non-volatile memory claimed to be significantly faster with similar density compared to NAND.

Production scheduled to begin in 2016 was delayed until the second half of 2017. In 2017, Samsung combined its V-NAND technology with eUFS 3D IC stacking to produce a 512 GB flash memory chip, with eight stacked 64-layer V-NAND dies.

In 2019, Samsung produced a 1 TB flash chip with eight stacked 96-layer V-NAND dies, along with quad-level cell (QLC) technology (4-bit per transistor), equivalent to 2 trillion transistors, the highest transistor count of any IC chip. In 2020, Samsung Electronics planned to produce the 5 nm node, using FinFET and EUV technology.

In 2024, Samsung outlined it's roadmap to include production of a 2 nm chip in 2025. In May 2021, IBM announced the creation of the first 2 nm computer chip, with parts supposedly being smaller than human DNA. Microprocessor architects report that semiconductor advancement has slowed industry-wide since around 2010, below the pace predicted by Moore's law.

Brian Krzanich, the former CEO of Intel, announced in 2015, "Our cadence today is closer to two and a half years than two." Intel stated in 2015 that improvements in MOSFET devices have slowed, starting at the 22 nm feature width around 2012, and continuing at 14 nm.

Pat Gelsinger, former Intel CEO, stated at the end of 2023 that "we're no longer in the golden era of Moore's Law, it's much, much harder now, so we're probably doubling effectively closer to every three years now, so we've definitely seen a slowing." The physical limits to transistor scaling have been reached due to source-to-drain leakage, limited gate metals and limited options for channel material.

Other approaches are being investigated, which do not rely on physical scaling. These include the spin state of electron spintronics, tunnel junctions, and advanced confinement of channel materials via nano-wire geometry.

Spin-based logic and memory options are being developed actively in labs. image of graphene in its hexagonal lattice structure |alt=refer to caption Various forms of graphene are being studied for graphene electronics. Graphene nanoribbon transistors have shown promise since their appearance in publications in 2008.

Bulk graphene has a band gap of zero and thus cannot be used in transistors because of its constant conductivity, an inability to turn off. The zigzag edges of the nanoribbons introduce localized energy states in the conduction and valence bands and thus a bandgap that enables switching when fabricated as a transistor.

As an example, a typical GNR of width of 10 nm has a desirable bandgap energy of 0.4 eV. ) More research will need to be performed, however, on sub-50 nm graphene layers, as its resistivity value increases and thus electron mobility decreases. ASML's 'Our Stories', Gordon Moore about Moore's Law, ASML Holding Moore's Law at Intel

Text derived from https://en.wikipedia.org/w/index.php?oldid=1378571502 under CC BY-SA 4.0; modifications have been made.

References

  1. ↩Wikipedia “Moore's law” revision 1378571502 · retrieved 2026-10-20 date of foundation (×1) · confidence 0.95 revision URL

Provenance

snapshot enwiki-001378571502 · captured 2026-10-04 · ledger · version history

Cite this page as: encyclopegia.org, “Moore's law”, snapshot enwiki-001378571502. https://encyclopegia.org/a/moore-s-law