Lesson plan

MP 3008

The 9×19mm MP 3008 (Maschinenpistole 3008 or "machine pistol 3008", also Volks-MP.3008 and Gerät Neumünster ) was a German last ditch submachine gun manufactured towards the end of World War II in early 1945. Also known as the Volksmaschinenpistole ("people's machine pistol"), the weapon was based on the Sten Mk II submachine gun, except for its vertical magazine; some had additional pistol grips. The MP 3008 was an emergency measure, designed at a time when Germany was at the point of collapse. Desperately short of raw materials, the Germans sought to produce a radically cheaper alternative to their standard submachine gun, the MP 40. The MP 3008 was a simple blowback design operating from an open bolt. It was crudely manufactured in small machine shops and variations were common. Typically, the magazine was bottom-mounted unlike the side-mounted Sten. Initially all steel without handgrips, the wire buttstock was welded to the frame and was typically triangular, however the design changed as conditions inside Germany worsened and on final guns wooden stocks and other variations are found. The Gerät Potsdam (MP 749 (e)), another, earlier, version of the Sten Mk II produced by Mauser in 1944, was an exact copy of the original Sten, right down to its manufacturing stamps in an effort to conceal its origin for clandestine operations.…

Back to article

Article summary

The 9×19mm MP 3008 (Maschinenpistole 3008 or "machine pistol 3008", also Volks-MP.3008 and Gerät Neumünster ) was a German last ditch submachine gun manufactured towards the end of World War II in early 1945. Also known as the Volksmaschinenpistole ("people's machine pistol"), the weapon was based on the Sten Mk II submachine gun, except for its vertical magazine; some had additional pistol grips. The MP 3008 was an emergency measure, designed at a time when Germany was at the point of collapse. Desperately short of raw materials, the Germans sought to produce a radically cheaper alternative to their standard submachine gun, the MP 40. The MP 3008 was a simple blowback design operating from an open bolt. It was crudely manufactured in small machine shops and variations were common. Typically, the magazine was bottom-mounted unlike the side-mounted Sten. Initially all steel without handgrips, the wire buttstock was welded to the frame and was typically triangular, however the design changed as conditions inside Germany worsened and on final guns wooden stocks and other variations are found. The Gerät Potsdam (MP 749 (e)), another, earlier, version of the Sten Mk II produced by Mauser in 1944, was an exact copy of the original Sten, right down to its manufacturing stamps in an effort to conceal its origin for clandestine operations.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.