MPT-1327

MPT 1327 is an open industry standard for trunked radio communications networks.

Uses your system voice; voice and rate in settings.

Snapshot

≈ 6 min read

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

MPT 1327 is an open industry standard for trunked radio communications networks. Developed in the United Kingdom by the Department of Trade and Industry (DTI) and the Radiocommunications Agency (now part of Ofcom), it was first published in January 19881.

Because MPT 1327 was published as a non-proprietary standard, it was adopted globally by numerous equipment vendors and system operators throughout Europe, Australasia, South Africa, and parts of Asia and the Americas. While historically one of the most widely deployed analogue trunking protocols in public utility, commercial transport, and industrial sectors, MPT 1327 systems have increasingly been superseded by digital trunking standards, notably DMR Tier III, TETRA, and NXDN.

MPT1327 advantages and features

The advantage of MPT 1327 over TETRA is the increased availability, lower cost of equipment, the ease of installation, the familiarity with the equipment, and many believe that MPT 1327 is superior to TETRA, due to its uncompressed FM audio, and greater receiver sensitivity. MPT1327 control channel signalling is more resilient, since the TETRA protocol uses a complex modulation scheme that requires a far higher Signal to Noise ratio to function than 1,200 bit/s FFSK signalling.

Systems based on MPT 1327 only require one, but usually use two or more radio channels per site. Channels can be 12.5 or 25 kHz bandwidth, and can be any variety of channel spacings, with 6.25 kHz or 12.5 kHz being typical. At least one of these channels is defined as the control channel (CCH) and all other channels are traffic channels (TCs) used for speech calls.

A typical installation will have around 6–10 channels. A 7-channel trunk, correctly engineered, is capable of handling in excess of 3,000 mobile units. The capacity of the system increases dramatically with the number of traffic channels.

For example, 1 traffic channel with queuing can not handle many customers, perhaps 2 minicabs with 20 mobiles. In effect this would be a CBS with queuing. However, a 7 channel trunked system can handle 40 minicabs with 20 mobiles with ease.

The Erlang formulas are typically used for calculating system capacity.

Spectrum efficiency

Whilst MPT 1327 systems, unlike DMR or dPMR, do not employ digital speech compression to gain any Spectral Efficiency (voice channels per 6.25 kHz), there are several methods used that increase the Spectrum Efficiency (Erlangs per square kilometre, per 6.25 kHz). A spectrum efficiency advantage over a 4-slot TDMA system like TETRA is in areas where low-bandwidth channels are required.

The absolute minimum TETRA installation would require a 25 kHz bandwidth in order to carry a control slot and three traffic slots. The absolute minimum MPT1327 assignment is a single non-dedicated control channel, utilising 12.5 kHz, in most cases. A non-dedicated control channel can be used as a traffic channel when all the other traffic channels are busy.

This can be useful if the site is part of a multi-site network and has a very low traffic profile as the site could have a single channel rather than at least two freeing up one channel for use elsewhere. The disadvantage is loss of queuing, and data cannot be sent on the control channel whilst it is in traffic mode.

A non-dedicated CCH should not be used as a "reserve tank" for a busy site as the lack of signalling will seriously affect the operation of the site.

Time-shared control channels and channel pooling

Some MPT 1327 networks can also time-share control channels, which can be useful if the network has limited frequency availability, as it frees up channels for use as traffic channels, which can also be pooled across sites so the network capacity follows the traffic. This is another advantage of MPT 1327 (and dPMR) over TDMA-based systems such as TETRA and DMR, which cannot pool traffic channels so efficiently (if at all).

The disadvantage of using a time-shared CCH is that it slows down registration and calls and requires some customization of the registration process, so is only useful if the network has a patient user community!

Speech and data

Speech is sent as narrowband frequency modulation. Data messages between mobiles and the network are exchanged on the control channel at 1,200 bits per second using FFSK signalling, or a specific "modem call", known as "non-prescribed data" can be established, whereby free-form 1,200 baud data can be exchanged on a traffic channel without tying up the control channel.

With the use of special modems, the speed can be 19,200 bit/s. This, along with Short Data Messaging and Status Messaging via the control channel makes an MPT1327 network ideal for managing AVL for asset management, meter reading and SCADA networks, the advantage being that the network can be used for this sort of application whilst still carrying voice traffic.

Traffic types

Mobile-mobile in a cell Mobile-mobile in different cells Mobile-line access unit via landline or radio Mobile-dispatcher station via landline or radio Mobile-PABX, Mobile-PSTN

Data communication

Status messages on the control channel (5-bit data length) Short data messages on the control channel (186-bit data length) Transparent data transmission on the TC (data communication).

Calls

Point to point connections Group calls with talk entitlement Group calls without talk entitlement (broadcast calls) Broadcast calls can be used to make announcements to the entire customer base on a trunked system. For example, if work is to be carried out on the trunked system, the owner of the system can initiate a Broadcast Call which calls every mobile on the system.

However, the mobiles may not have talk entitlement, so the PTT may not work. By this means the owner can announce to all customers a short period of inoperation due to maintenance.

Text derived from https://en.wikipedia.org/w/index.php?oldid=1374729953 under CC BY-SA 4.0; modifications have been made.

References

  1. ↩Wikipedia “MPT-1327” revision 1374729953 · retrieved 2026-10-20 publication date (×1) · confidence 0.95 revision URL