Lesson plan
NW S
The NW type S was a series of large automobiles manufactured by Nesselsdorfer Wagenbau-Fabriks-Gesellschaft A.G. (NW, now known as Tatra), in Moravia, in what was then Austria-Hungary. Hans Ledwinka, who left the company in 1902, was hired back in 1905. Immediately, he started working on a new car with a modern and progressive design. Some of the new features included overhead valves, actuated by overhead camshaft (OHC), and hemispherical combustion chamber. The water-cooled engine was mounted at three points and the engine block had large service access doors. The engine and the gearbox formed one unit, the monoblock. The gearbox itself was of a bell shape with only five gears. Two of the gears were ring type with teeth on the inside surface. Individual speeds were engaged by moving the gears radially. The rear axle was driven by a drive shaft in lieu of chains. The S4 and S6 with four- and six-cylinder engines, respectively, were able to reach maximum speeds of 80 km/h and 100 km/h (50/62 mph). The S 18/24 and 16/20 models developed , while the S4 20/30 offered . The later, six-cylinder S6 40/50 version was an S4 with two cylinders added; it produced and was introduced in 1910. The total production of both models was 74 units.
Article summary
The NW type S was a series of large automobiles manufactured by Nesselsdorfer Wagenbau-Fabriks-Gesellschaft A.G. (NW, now known as Tatra), in Moravia, in what was then Austria-Hungary. Hans Ledwinka, who left the company in 1902, was hired back in 1905. Immediately, he started working on a new car with a modern and progressive design. Some of the new features included overhead valves, actuated by overhead camshaft (OHC), and hemispherical combustion chamber. The water-cooled engine was mounted at three points and the engine block had large service access doors. The engine and the gearbox formed one unit, the monoblock. The gearbox itself was of a bell shape with only five gears. Two of the gears were ring type with teeth on the inside surface. Individual speeds were engaged by moving the gears radially. The rear axle was driven by a drive shaft in lieu of chains. The S4 and S6 with four- and six-cylinder engines, respectively, were able to reach maximum speeds of 80 km/h and 100 km/h (50/62 mph). The S 18/24 and 16/20 models developed , while the S4 20/30 offered . The later, six-cylinder S6 40/50 version was an S4 with two cylinders added; it produced and was introduced in 1910. The total production of both models was 74 units.
Key claims
No claims recorded.
Discussion questions
- Summarise the article in your own words. Which single claim would you verify first, and why?
- Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
- If two sources disagreed about one of these facts, what would you need in order to trust one over the other?
Bibliography
No sources recorded.
Key claims and bibliography are generated from the same tracked claims and sources as the article page.