Lesson plan

Packet Layer Protocol

Packet Layer Protocol or PLP operates on the network layer of the OSI model for the X.25 protocol suite. It is responsible for addressing, routing, and delivering data packets across different networks. PLP manages the packet exchanges between DTE (data terminal) devices across VCs (virtual circuits). PLP also can be used on ISDN using Link Access Procedures, D channel (LAPD). There are 5 modes of PLP: call setup, data transfer, idle, call clearing, and restarting. * Call setup mode is used to create VCs (virtual circuits) between DTE devices. A PLP uses the 14-digit X.121 addressing scheme to set up the virtual circuit. * Data transfer mode is used to send data between DTE devices across a virtual circuit. At this level PLP handles segmentation and reassembly, bit padding, error control and flow control. * Idle mode is used when a virtual circuit is established but there is no data transfer happening. * Call clearing mode is used to end sessions between DTE devices and to terminate VCs. * Restarting mode is used to synchronize the transmission between a DTE device and its locally connected DCE (data communications) device. There are 4 types of PLP packet fields: * General Format Identifier (GFI): Identifies packet parameters (whether it is data or control information), what type of windowing is being used, and whether delivery confirmation is needed.…

Back to article

Article summary

Packet Layer Protocol or PLP operates on the network layer of the OSI model for the X.25 protocol suite. It is responsible for addressing, routing, and delivering data packets across different networks. PLP manages the packet exchanges between DTE (data terminal) devices across VCs (virtual circuits). PLP also can be used on ISDN using Link Access Procedures, D channel (LAPD). There are 5 modes of PLP: call setup, data transfer, idle, call clearing, and restarting. * Call setup mode is used to create VCs (virtual circuits) between DTE devices. A PLP uses the 14-digit X.121 addressing scheme to set up the virtual circuit. * Data transfer mode is used to send data between DTE devices across a virtual circuit. At this level PLP handles segmentation and reassembly, bit padding, error control and flow control. * Idle mode is used when a virtual circuit is established but there is no data transfer happening. * Call clearing mode is used to end sessions between DTE devices and to terminate VCs. * Restarting mode is used to synchronize the transmission between a DTE device and its locally connected DCE (data communications) device. There are 4 types of PLP packet fields: * General Format Identifier (GFI): Identifies packet parameters (whether it is data or control information), what type of windowing is being used, and whether delivery confirmation is needed.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.