Lesson plan
Phono input
Phono input is a set of input jacks, usually mini jacks or RCA connectors, located on the rear panel of a preamp, mixer or amplifier, especially on early radio sets, to which a phonograph or turntable is attached. Modern phono cartridges give a very low level output signal of the order of a few millivolts which the circuitry amplifies and equalizes. Phonograph recordings are made with high frequencies boosted and the low frequencies attenuated: during playback the frequency response changes are reversed. This reduces background noise, including clicks or pops, and also conserves the amount of physical space needed for each groove, by reducing the size of the larger low-frequency undulations. This is accomplished in the amplifier with a phono input that incorporates standardized RIAA equalization circuitry. Through at least the 1980s, the phono input was widely available on consumer stereo equipment—even some larger boomboxes had them. By the 2000s only very sophisticated and expensive stereo receivers retained the phono input, since most users were expected to use digital music formats such as CD or satellite radio. Some newer low-cost turntables include built-in amplifiers to produce line-level (one volt) outputs; devices are available that perform this conversion for use with computers; or older amplifiers or radio receivers can be used.…
Article summary
Phono input is a set of input jacks, usually mini jacks or RCA connectors, located on the rear panel of a preamp, mixer or amplifier, especially on early radio sets, to which a phonograph or turntable is attached. Modern phono cartridges give a very low level output signal of the order of a few millivolts which the circuitry amplifies and equalizes. Phonograph recordings are made with high frequencies boosted and the low frequencies attenuated: during playback the frequency response changes are reversed. This reduces background noise, including clicks or pops, and also conserves the amount of physical space needed for each groove, by reducing the size of the larger low-frequency undulations. This is accomplished in the amplifier with a phono input that incorporates standardized RIAA equalization circuitry. Through at least the 1980s, the phono input was widely available on consumer stereo equipment—even some larger boomboxes had them. By the 2000s only very sophisticated and expensive stereo receivers retained the phono input, since most users were expected to use digital music formats such as CD or satellite radio. Some newer low-cost turntables include built-in amplifiers to produce line-level (one volt) outputs; devices are available that perform this conversion for use with computers; or older amplifiers or radio receivers can be used.…
Key claims
No claims recorded.
Discussion questions
- Summarise the article in your own words. Which single claim would you verify first, and why?
- Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
- If two sources disagreed about one of these facts, what would you need in order to trust one over the other?
Bibliography
No sources recorded.
Key claims and bibliography are generated from the same tracked claims and sources as the article page.