Lesson plan

Plastic bending

Plastic bending is a nonlinear behavior particular to members made of ductile materials that frequently achieve much greater ultimate bending strength than indicated by a linear elastic bending analysis. In both the plastic and elastic bending analyses of a straight beam, it is assumed that the strain distribution is linear about the neutral axis (plane sections remain plane). In an elastic analysis this assumption leads to a linear stress distribution but in a plastic analysis the resulting stress distribution is nonlinear and is dependent on the beam's material. The limiting plastic bending strength M_r (see Plastic moment) can generally be thought of as an upper limit to a beam's load–carrying capability as it only represents the strength at a particular cross–section and not the load–carrying capability of the overall beam. A beam may fail due to global or local instability before M_r is reached at any point on its length. Therefore, beams should also be checked for local buckling, local crippling, and global lateral–torsional buckling modes of failure. Note that the deflections necessary to develop the stresses indicated in a plastic analysis are generally excessive, frequently to the point of incompatibility with the function of the structure. Therefore, separate analysis may be required to ensure design deflection limits are not exceeded.…

Back to article

Article summary

Plastic bending is a nonlinear behavior particular to members made of ductile materials that frequently achieve much greater ultimate bending strength than indicated by a linear elastic bending analysis. In both the plastic and elastic bending analyses of a straight beam, it is assumed that the strain distribution is linear about the neutral axis (plane sections remain plane). In an elastic analysis this assumption leads to a linear stress distribution but in a plastic analysis the resulting stress distribution is nonlinear and is dependent on the beam's material. The limiting plastic bending strength M_r (see Plastic moment) can generally be thought of as an upper limit to a beam's load–carrying capability as it only represents the strength at a particular cross–section and not the load–carrying capability of the overall beam. A beam may fail due to global or local instability before M_r is reached at any point on its length. Therefore, beams should also be checked for local buckling, local crippling, and global lateral–torsional buckling modes of failure. Note that the deflections necessary to develop the stresses indicated in a plastic analysis are generally excessive, frequently to the point of incompatibility with the function of the structure. Therefore, separate analysis may be required to ensure design deflection limits are not exceeded.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.