Lesson plan
Pressure grouting
Pressure grouting or jet grouting involves injecting a grout material into otherwise inaccessible but interconnected pore or void space of which neither the configuration or volume are known, and is often referred to simply as grouting. The grout may be a cementitious, resinous, or solution chemical mixture. Some types of injected grout may not penetrate, and may subsequently shrink and pull away even when coarse sediments have been penetrated. Different grout may be needed for fine grained and coarse grained soils in the grouted area. The greatest use of pressure grouting is to improve geomaterials (soil and rock). The purpose of grouting can be either to strengthen a formation or to reduce water flow through it. It is also used to correct faults in concrete and masonry structures. In 1986 a study conducted by the Hazardous Waste Engineering Research Laboratory of the US Environmental Protection Agency tested acrylate, Portland cement and different compositions of silicate material to see if the grouting techniques of direct injection or jet grouting could be used to bottom seal hazardous waste sites with an "inert, impermeable and continuous" horizontal barrier.…
Article summary
Pressure grouting or jet grouting involves injecting a grout material into otherwise inaccessible but interconnected pore or void space of which neither the configuration or volume are known, and is often referred to simply as grouting. The grout may be a cementitious, resinous, or solution chemical mixture. Some types of injected grout may not penetrate, and may subsequently shrink and pull away even when coarse sediments have been penetrated. Different grout may be needed for fine grained and coarse grained soils in the grouted area. The greatest use of pressure grouting is to improve geomaterials (soil and rock). The purpose of grouting can be either to strengthen a formation or to reduce water flow through it. It is also used to correct faults in concrete and masonry structures. In 1986 a study conducted by the Hazardous Waste Engineering Research Laboratory of the US Environmental Protection Agency tested acrylate, Portland cement and different compositions of silicate material to see if the grouting techniques of direct injection or jet grouting could be used to bottom seal hazardous waste sites with an "inert, impermeable and continuous" horizontal barrier.…
Key claims
No claims recorded.
Discussion questions
- Summarise the article in your own words. Which single claim would you verify first, and why?
- Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
- If two sources disagreed about one of these facts, what would you need in order to trust one over the other?
Bibliography
No sources recorded.
Key claims and bibliography are generated from the same tracked claims and sources as the article page.