Lesson plan

Procon-ten

procon-ten (lower case initial "p") (an acronym for Programmed Contraction-Tension) is a proprietary Safety Restraint System (SRS), used by German car manufacturer Audi from 1986 until the mid-1990s. Audi was one of the last German manufacturers to employ airbags in their cars, mainly due to the high reliability and cost-effectiveness of the technology they trademarked as "procon-ten". The procon-ten system used thick cables, similar to winch cables, running around the rear of the engine, and linked to it. In the event of a frontal impact, the force and momentum of the impact would shift the engine rearwards, tensioning and 'pulling' the cables, which were in turn connected to the steering column and seat belt mounts. When the cable was pulled tight by the engine, the cables would pull the steering wheel towards the front of the car, clear of the driver, and also remove any slack in the seat belts, holding the occupants more firmly in their seats until the accident had finished. Audi engines were by tradition mounted longitudinally, in front of the front wheels, as opposed to transverse engine configuration. This meant the engine was very close to the front bumper, (especially on 5 cylinder variants) and that the radiator often had to be offset to halfway down one side of the engine bay.…

Back to article

Article summary

procon-ten (lower case initial "p") (an acronym for Programmed Contraction-Tension) is a proprietary Safety Restraint System (SRS), used by German car manufacturer Audi from 1986 until the mid-1990s. Audi was one of the last German manufacturers to employ airbags in their cars, mainly due to the high reliability and cost-effectiveness of the technology they trademarked as "procon-ten". The procon-ten system used thick cables, similar to winch cables, running around the rear of the engine, and linked to it. In the event of a frontal impact, the force and momentum of the impact would shift the engine rearwards, tensioning and 'pulling' the cables, which were in turn connected to the steering column and seat belt mounts. When the cable was pulled tight by the engine, the cables would pull the steering wheel towards the front of the car, clear of the driver, and also remove any slack in the seat belts, holding the occupants more firmly in their seats until the accident had finished. Audi engines were by tradition mounted longitudinally, in front of the front wheels, as opposed to transverse engine configuration. This meant the engine was very close to the front bumper, (especially on 5 cylinder variants) and that the radiator often had to be offset to halfway down one side of the engine bay.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.