Lesson plan

Productionisation

Productionisation (Commonwealth English) or productionization (American English) is the process of turning a prototype of a design into a version that can be more easily mass-produced. It is mostly a necessary step in the development of any product, since it is rare that the initial design is free from flaws or construction methods which make it difficult or more expensive to manufacture. Prototypes are very often constructed by hand, or with more limited tooling. This is done to save costs where the design may not even be subsequently approved for manufacture. Once the go-ahead for a production run is given, the much more costly production tooling can be ordered. At this stage, the design itself may need to be reworked or altered to streamline production. The goal is to reduce costs as much as possible at the assembly stage, since costs will be multiplied by the number of units produced. For example, a prototype might be assembled using nuts and bolts, but in production such fasteners might be replaced by captive nuts or threaded holes built into the parts, making assembly much faster, easier and therefore cheaper. Sometimes limited runs of a design might be manufactured without full productionisation.…

Back to article

Article summary

Productionisation (Commonwealth English) or productionization (American English) is the process of turning a prototype of a design into a version that can be more easily mass-produced. It is mostly a necessary step in the development of any product, since it is rare that the initial design is free from flaws or construction methods which make it difficult or more expensive to manufacture. Prototypes are very often constructed by hand, or with more limited tooling. This is done to save costs where the design may not even be subsequently approved for manufacture. Once the go-ahead for a production run is given, the much more costly production tooling can be ordered. At this stage, the design itself may need to be reworked or altered to streamline production. The goal is to reduce costs as much as possible at the assembly stage, since costs will be multiplied by the number of units produced. For example, a prototype might be assembled using nuts and bolts, but in production such fasteners might be replaced by captive nuts or threaded holes built into the parts, making assembly much faster, easier and therefore cheaper. Sometimes limited runs of a design might be manufactured without full productionisation.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.