Lesson plan

Program counter

computer introduced in 1952. Lights in the middle display the contents of various registers. The instruction counter is at the lower left. A program counter (PC) is a register that stores where a computer program is being executed by a processor. It is also commonly called the instruction pointer (IP) in Intel x86 and Itanium microprocessors, and sometimes called the instruction address register (IAR), the instruction counter, or just part of the instruction sequencer. Usually, a PC stores the memory address of an instruction. Further, it usually is incremented after fetching an instruction, and therefore points to the next instruction to be executed. For a processor that increments before fetch, the PC points to the instruction being executed. In some processors, the PC points some distance beyond the current instruction. For instance, in the ARM7, the value of PC visible to the programmer reflects instruction prefetching and reads as the address of the current instruction plus 8 in ARM State, or plus 4 in Thumb State. For modern processors, the location of execution in the program is complicated by instruction-level parallelism and out-of-order execution. By default, a processor fetches instructions sequentially from memory, but a control transfer instruction changes the sequence by writing a value in the PC.…

Back to article

Article summary

computer introduced in 1952. Lights in the middle display the contents of various registers. The instruction counter is at the lower left. A program counter (PC) is a register that stores where a computer program is being executed by a processor. It is also commonly called the instruction pointer (IP) in Intel x86 and Itanium microprocessors, and sometimes called the instruction address register (IAR), the instruction counter, or just part of the instruction sequencer. Usually, a PC stores the memory address of an instruction. Further, it usually is incremented after fetching an instruction, and therefore points to the next instruction to be executed. For a processor that increments before fetch, the PC points to the instruction being executed. In some processors, the PC points some distance beyond the current instruction. For instance, in the ARM7, the value of PC visible to the programmer reflects instruction prefetching and reads as the address of the current instruction plus 8 in ARM State, or plus 4 in Thumb State. For modern processors, the location of execution in the program is complicated by instruction-level parallelism and out-of-order execution. By default, a processor fetches instructions sequentially from memory, but a control transfer instruction changes the sequence by writing a value in the PC.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.