Pump drill

Uses your system voice; voice and rate in settings.

Snapshot

≈ 4 min read

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

A pump drill is a simple hand-powered device used to impart a rapid rotating motion to a rod (the spindle or drill shaft). It can be used for fire making or as a drill to make holes in various materials. It consists of: the drill shaft, a narrow board with a hole through the center, a weight (usually a heavy disc) acting as a flywheel, and a length of cord. The weight is attached to the shaft, near the bottom end, and the hole board is slipped over the top. The cord is run through a hole or slot near the top of the shaft and attached to both ends of the hole board. The length of the cord is such that, at its lowest position, the board lies just above the weight. The end of the shaft usually has a slot or hole that can hold a hard bit that does the actual drilling, either by abrasion or by cutting. For wood, the bit may be an auger bit or a simple triangular blade that can cut while rotating in either direction. with a pump drill. To use, the shaft is first turned by hand so that the cord wraps around the top part, as much as possible, and the board is as the highest position. A smooth downward pressure is exerted on the board, causing the shaft to rapidly spin. Once the bottom is reached, the pressure is relieved.…

A pump drill is a simple hand-powered device used to impart a rapid rotating motion to a rod (the spindle or drill shaft). It can be used for fire making or as a drill to make holes in various materials. It consists of: the drill shaft, a narrow board with a hole through the center, a weight (usually a heavy disc) acting as a flywheel, and a length of cord. The weight is attached to the shaft, near the bottom end, and the hole board is slipped over the top. The cord is run through a hole or slot near the top of the shaft and attached to both ends of the hole board. The length of the cord is such that, at its lowest position, the board lies just above the weight. The end of the shaft usually has a slot or hole that can hold a hard bit that does the actual drilling, either by abrasion or by cutting. For wood, the bit may be an auger bit or a simple triangular blade that can cut while rotating in either direction. with a pump drill. To use, the shaft is first turned by hand so that the cord wraps around the top part, as much as possible, and the board is as the highest position. A smooth downward pressure is exerted on the board, causing the shaft to rapidly spin. Once the bottom is reached, the pressure is relieved. The weight then keeps the shaft spinning so that the cord wind again around it, in the opposite sense, pulling the board up to the starting position, much like a yo-yo or button whirligig. The process then can be repeated.

See also

Bow drill, strap drill Hand drill

References

Text derived from https://en.wikipedia.org/w/index.php?oldid=1264029700 under CC BY-SA 4.0; modifications have been made.

Sources cited in this revision

2 named source(s) extracted from the cited revision. A source with no author is shown by its publication; nothing is invented.