random wire antenna

Uses your system voice; voice and rate in settings.

Q379336Snapshot

≈ 7 min read

Names in other languages

  • Englishrandom wire antenna
  • ItalianoAntenna random wire
  • ไทยRandom wire antenna
  • fiPitkälanka-antenni
  • DeutschLangdrahtantenne
  • Françaisantenne long-fil
  • Magyarhosszú sugárzó
  • PolskiLong wire

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

s and a balun. When installed the wire is supported by buildings or trees using the insulators to prevent a short circuit to ground. A random wire antenna is a radio antenna consisting of a long wire suspended above the ground, whose length does not bear a particular relation to the wavelength of the radio waves used, but is typically chosen more for convenient fit between the available supports, or the length of wire at hand, rather than selecting length to be resonant on any particular frequency.

The wire may be straight or it may be strung back and forth between trees or walls just to get as much wire into the air as feasible.

Due to the great variability of the (unplanned) antenna structure, the random wire’s effectiveness can vary erratically from one installation to another, and a single random wire antenna can have wildly different reception / transmission strength in one direction than it achieves in another azimuth direction about 70°~140° different, and finally reception / transmission strengths and directions can be wildly different on only moderately different frequencies.

Random wire antennas are typically fed at one end against a suitable counterpoise (such as earth ground or a parallel wire hidden under the grass below the elevated antenna wire).…

s and a balun. When installed the wire is supported by buildings or trees using the insulators to prevent a short circuit to ground. A random wire antenna is a radio antenna consisting of a long wire suspended above the ground, whose length does not bear a particular relation to the wavelength of the radio waves used, but is typically chosen more for convenient fit between the available supports, or the length of wire at hand, rather than selecting length to be resonant on any particular frequency.

The wire may be straight or it may be strung back and forth between trees or walls just to get as much wire into the air as feasible.

Due to the great variability of the (unplanned) antenna structure, the random wire’s effectiveness can vary erratically from one installation to another, and a single random wire antenna can have wildly different reception / transmission strength in one direction than it achieves in another azimuth direction about 70°~140° different, and finally reception / transmission strengths and directions can be wildly different on only moderately different frequencies.

Random wire antennas are typically fed at one end against a suitable counterpoise (such as earth ground or a parallel wire hidden under the grass below the elevated antenna wire). A combination of two random parallel wires of different length is actually the original zeppelin antenna as defined in the patent from 1909 since this patent does not specify any length to wavelength ratios. With a proper matching unit and a common-mode choke a zeppelin antenna that is end-fed-half-wave in the 17m band can be tuned to all shortwave frequencies.

They are widely used as receiving antennas on the long wave, medium wave, and short wave bands, as well as transmitting antennas on these bands for small outdoor, temporary or emergency transmitting stations, as well as in situations where more permanent antennas cannot be installed.

Radiation pattern

The radiation pattern of a thin wire antenna is easily predictable using antenna modeling. For a straight wire, the radiation pattern can be described by axially symmetric multipole moments with no component along the wire direction; as the length of the wire is increased, higher multipole contributions become more prominent and multiple lobes (maxima) at angles to the antenna axis develop. Under about 0.6  a wire antenna will have a single lobe with a maximum at right angles to the axis.

Above this the lobe will split into two conical lobes with their maximum directed at equal angles to the wire, and a null between them. This results in four azimuth angles at which the gain is maximum. As the length of wire in wavelengths increases, the number of lobes increases and the maxima become increasingly sharp. Any unpredictability of the radiation pattern is caused by uncontrolled interaction with nearby matter (such as soil or structures).

For example, a long wire antenna close to the ground will form a leaky two-conductor transmission line and therefore also act somewhat as a traveling wave antenna, with reception off the end of the wire (the system is no longer axially symmetric). A folded or zig-zag antenna may exhibit a more complex pattern as there are even fewer symmetry constraints on the dipole moments that may contribute. Long wire antennas are reported to be more effective for reception than multi-element antennas such as Yagi or quad antennas with the same length of wire.

Construction

A random wire antenna usually consists of a long (at least one quarter wavelength) wire with one end connected to the radio and the other in free space, arranged in any way most convenient for the space available. Ideally, it is strung as high as possible between trees or buildings, with any bends as obtuse as possible, and with the ends insulated from supports. If used for transmitting, a random wire antenna usually will also require an antenna tuner, as it has an unpredictable impedance that varies with frequency.

One side of the output of the tuner is connected directly to the antenna, without a transmission line, the other to a good earth ground. A wire near an odd number of a quarter-waves in length works best; in contrast, a wire near an even number of quarter-wavelengths long, although fine for receiving, on transmit will exceed the matching ability of most small tuners, unless first fed through an unun with a large transform ratio. Even without a good earth, the antenna will still radiate, although its performance will be poor.

A poorly grounded antenna typically manages to radiate by capacitively coupling to any nearby conducting material; transmitting through the antenna without an ample ground system is not recommended. The ground for a random wire antenna may be chosen by experimentation.

The antenna tuner ground could be connected to a nearby cold water pipe (if the pipe used reaches the soil via an all-steel or all-copper segment) or one or several wires laid on the floor or ground, one of which is approximately one-quarter wavelength long, or the ground can be connected to one or several randomly laid-out counterpoise wires under the antenna, at least one of which is a quarter-wavelength.

Text derived from https://en.wikipedia.org/w/index.php?oldid=1373975505 under CC BY-SA 4.0; modifications have been made.

Provenance

snapshot random-wire-antenna-044025-979835c6a81009c0 · hash 979835c6a81009c040bee8feafe30396f1d4f2d76d21a609d6d181e8f995bb98 · captured 1788913164.0 · version history

Cite this page as: encyclopegia.org, “random wire antenna”, snapshot random-wire-antenna-044025-979835c6a81009c0. https://encyclopegia.org/a/random-wire-antenna

Sources cited in this revision

No external citation was extracted for this revision. That is a statement about the source, not a claim that none exists.