Lesson plan

Repeater insertion

Repeater insertion is a technique used to reduce time delays associated with long wire lines in integrated circuits. This technique involves cutting the long wire into one or more shorter wires, and then inserting a repeater between each pair of newly created short wires. The time it takes for a signal to travel from one end of a wire to the other end is known as wire-line delay or just delay. In an integrated circuit, this delay is characterized by RC, the resistance of the wire (R) multiplied by the wire's capacitance (C). Thus, if the wire's resistance is 100 ohms and its capacitance is 0.01 microfarad (μF), the wire's delay is one microsecond (μs). The resistance of a wire on an integrated circuit is directly proportional, or linear, according to the wire's length. If a 1 mm length of the wire has 100 ohms resistance, then a 2 mm length will have 200 ohms resistance. For the purposes of our highly simplified discussion, the capacitance of a wire also increases linearly along its length. If a 1 mm length of the wire has 0.01 μF capacitance, a 2 mm length of the wire will have 0.02 μF, a 3 mm wire will have 0.03 μF, and so on. Thus, the time delay through a wire increases with the square of the wire's length. This is true, to first order, for any wire whose cross-section remains constant along the length of the wire.…

Back to article

Article summary

Repeater insertion is a technique used to reduce time delays associated with long wire lines in integrated circuits. This technique involves cutting the long wire into one or more shorter wires, and then inserting a repeater between each pair of newly created short wires. The time it takes for a signal to travel from one end of a wire to the other end is known as wire-line delay or just delay. In an integrated circuit, this delay is characterized by RC, the resistance of the wire (R) multiplied by the wire's capacitance (C). Thus, if the wire's resistance is 100 ohms and its capacitance is 0.01 microfarad (μF), the wire's delay is one microsecond (μs). The resistance of a wire on an integrated circuit is directly proportional, or linear, according to the wire's length. If a 1 mm length of the wire has 100 ohms resistance, then a 2 mm length will have 200 ohms resistance. For the purposes of our highly simplified discussion, the capacitance of a wire also increases linearly along its length. If a 1 mm length of the wire has 0.01 μF capacitance, a 2 mm length of the wire will have 0.02 μF, a 3 mm wire will have 0.03 μF, and so on. Thus, the time delay through a wire increases with the square of the wire's length. This is true, to first order, for any wire whose cross-section remains constant along the length of the wire.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.