Ryde Pumping Station

The Ryde Pumping Station is a heritage-listed pumping station and offices located at Victoria Road, West Ryde, New South Wales, Australia.

Uses your system voice; voice and rate in settings.

≈ 3 min read

Cite, export and learn8 citation formats · 8 exports · lesson and quiz

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

The Ryde Pumping Station is a heritage-listed pumping station and offices located at Victoria Road, West Ryde, New South Wales, Australia. It was built from 18911 to 1921 by William Adams & Co. Ltd., State Monier Works, Refshaw & O'Brien. It is also known as Ryde Pumping Station and site, WP005 and West Ryde Pumping Station.

The property is owned by Sydney Water. It was added to the New South Wales State Heritage Register on 15 November 2002.

Pumping station

The first pumping station at Ryde was built by the Harbours and Rivers Department, and handed over to the newly formed Metropolitan Board of Water Supply & Sewerage (MBWS&S) in 1891. Water was delivered from Potts Hill Reservoir to a balance reservoir at West Ryde railway station.

From here a pair of vertical, compound, direct-acting, surface-condensing pumping engines (by J. Watts & Co. Birmingham), lifted 3,400 gal/min of water to Ryde tank and Chatswood, to supply Sydney's northern distribution system. By 1916 the need to further increase pumping capacity could no longer be accommodated in the existing station.

Land on the eastern boundary of the old station was acquired, and a second much larger pumping station built. The new station was completed during 1921 and commissioned on 15 September. Gradually the new station took over the pumping duties of the old until the old pumping station ceased to operate during November 1930.

The old station was used as a store until it was demolished in 1961. The new pumping station went through continual upgrades and amplifications to raise its pumping capacity from (including the old pumping station) in 1921, to in 1956, to (410ML/day) in 1973, to in 1982.

In 1921 the station was pumping to Chatswood, Pymble, Wahroonga, Hermitage, Mobbs Hill and Beecroft Reservoirs - thus to most of the North Shore. By 1982 the conversion to electrification was completed. With 13 pumping units installed and another on standby, the capacity of the station after electrification stood at .

The combination of electrification over steam, more powerful prime movers and improved suction mains, rising mains and manifolds, resulted in the great increase in capacity at the new station. This led to Ryde becoming the largest domestic water pumping station in Australia at that time.

Turpentine-Ironbark forest on Wianamatta shale was the main vegetation type for much of the Ryde area. A typical sample is that within the small reserve (Wallumatta Nature Reserve) at Twin Road, Ryde and includes Turpentine and Grey Gum.

During the 19th century much of the Ryde area was cleared for its timber and to provide land for farming while the post-WW II suburban expansion resulted in the further loss of extensive remnant areas of bushland. More recent treatment of the grounds reflects an attempt to soften the impact of the introduction of the many office buildings and demountables associated with the use of the place by Sydney Water and, until June 2001, Australian Water Technologies.

Text derived from https://en.wikipedia.org/w/index.php?oldid=1364978351 under CC BY-SA 4.0; modifications have been made.

References

  1. ↩Wikipedia “Ryde Pumping Station” revision 1364978351 · retrieved 2026-10-20 date of formation (×1) · confidence 0.95 revision URL

Provenance

snapshot enwiki-001364978351 · captured 2026-07-19 · ledger · version history

Cite this page as: encyclopegia.org, “Ryde Pumping Station”, snapshot enwiki-001364978351. https://encyclopegia.org/a/ryde-pumping-station