Sedimentary structures

Sedimentary structures include all kinds of features in sediments and sedimentary rocks, formed at the time of deposition. Sediments and sedimentary rocks are characterized by bedding, which occurs when layers of sediment, with different particle sizes are deposited on top of each other. These beds range from millimeters to centimeters thick and can even go to meters or multiple meters thick. Sedimentary structures such as cross-bedding, graded bedding, and ripple marks are utilized in stratigraphic studies. They help indicate the original position of strata in geologically complex terrains. They also provide insight into the depositional environment of the sediment.

Sedimentary structures include all kinds of features in sediments and sedimentary rocks, formed at the time of deposition. Sediments and sedimentary rocks are characterized by bedding, which occurs when layers of sediment, with different particle sizes are deposited on top of each other. These beds range from millimeters to centimeters thick and can even go to meters or multiple meters thick. Sedimentary structures such as cross-bedding, graded bedding, and ripple marks are utilized in stratigraphic studies. They help indicate the original position of strata in geologically complex terrains. They also provide insight into the depositional environment of the sediment.

Flow structures

There are two kinds of flow structures: bidirectional (multiple directions, back-and-forth) and unidirectional. Flow regimes in single-direction (typically fluvial) flow, which at varying speeds and velocities produce different structures, are called bedforms. In the lower flow regime, the natural progression is from a flat bed, to some sediment movement (saltation etc.), to ripples, to slightly larger dunes. Dunes have a vortex in the lee side of the dune. As the upper flow regime forms, the dunes become flattened out, and then produce antidunes. At higher still velocity, the antidunes are flattened and most sedimentation stops, as erosion takes over as the dominant process.

Bedforms vs. flow

Typical unidirectional bedforms represent a specific flow velocity, assuming typical sediments (sands and silts) and water depths, and a chart such as below can be used for interpreting depositional environments, with increasing water velocity going down the chart.

Secondary sedimentary structures

Secondary sedimentary structures form after primary deposition occurs or, in some cases, during the diagenesis of a sedimentary rock. Common secondary structures include any form of bioturbation, soft-sediment deformation, teepee structures, root-traces, and soil mottling. Liesegang rings, cone-in-cone structures, raindrop impressions, and vegetation-induced sedimentary structures would also be considered secondary structures. Secondary structures include fluid escape structures, formed when fluids escape from a sedimentary bed after deposition. Examples of fluid escape structures include dish structures, pillar structures, and vertical sheet structures.

See also

Reynolds number

Further reading

Prothero, D. R. and Schwab, F., 1996, Sedimentary Geology, pg. 43-64,

Text derived from https://en.wikipedia.org/w/index.php?oldid=1272908373 under CC BY-SA 4.0; modifications have been made.