Setpoint (control system)

Article summary

of a negative feedback system used to maintain a setpoint in the face of a disturbance using error-controlled regulation. Positive error means feedback is too small (controller calls for an increase), and negative error means feedback is too large (controller calls for a decrease). In cybernetics and control theory, a setpoint (SP; also set point) is the desired or target value for an essential variable, or process value (PV) of a control system, which may differ from the actual measured value of the variable. Departure of such a variable from its setpoint is one basis for error-controlled regulation using negative feedback for automatic control. A setpoint can be any physical quantity or parameter that a control system seeks to regulate, such as temperature, pressure, flow rate, position, speed, or any other measurable attribute. In the context of PID controller, the setpoint represents the reference or goal for the controlled process variable. It serves as the benchmark against which the actual process variable (PV) is continuously compared. The PID controller calculates an error signal by taking the difference between the setpoint and the current value of the process variable. Mathematically, this error is expressed as: : e(t) = SP - PV(t), where e(t) is the error at a given time t , SP is the setpoint, PV(t) is the process variable at time t .…

Key claims

No claims recorded.

Discussion questions

1. Summarise the article in your own words. Which single claim would you verify first, and why?
2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.