Lesson plan

Slow DoS attack

The term slow DoS attack (SDA) was introduced in 2013, to clearly define a specific category of denial-of-service attacks which make use of low-bandwidth rate to accomplish their purpose. Similar terms can be found in literature, such as: * application layer DoS, focusing on attacks targeting the application layer only, while a slow DoS attack may exploit lower-layers of the ISO/OSI stack * low-rate DoS, focusing on the characteristics of using a limited amount of attack bandwidth, hence, for instance, including also exploit-based threats Particularly, in order to reduce bandwidth, a slow DoS attack often acts at the application layer of the ISO/OSI stack (e.g. in case of timeout exploiting threats ), although this is not a requirement. Such layer is however easier to exploit in order to successfully attack a victim even by sending it a few bytes of malicious requests. The purpose of a slow DoS attack is (often, but not always ) to cause unavailability of a network service, by seizing all the connections the daemon is able to concurrently manage, at the application layer. Under such conditions, any new incoming connection, even from potentially legitimate clients, will not be accepted by the daemon, hence leading to a denial of service.…

Back to article

Article summary

The term slow DoS attack (SDA) was introduced in 2013, to clearly define a specific category of denial-of-service attacks which make use of low-bandwidth rate to accomplish their purpose. Similar terms can be found in literature, such as: * application layer DoS, focusing on attacks targeting the application layer only, while a slow DoS attack may exploit lower-layers of the ISO/OSI stack * low-rate DoS, focusing on the characteristics of using a limited amount of attack bandwidth, hence, for instance, including also exploit-based threats Particularly, in order to reduce bandwidth, a slow DoS attack often acts at the application layer of the ISO/OSI stack (e.g. in case of timeout exploiting threats ), although this is not a requirement. Such layer is however easier to exploit in order to successfully attack a victim even by sending it a few bytes of malicious requests. The purpose of a slow DoS attack is (often, but not always ) to cause unavailability of a network service, by seizing all the connections the daemon is able to concurrently manage, at the application layer. Under such conditions, any new incoming connection, even from potentially legitimate clients, will not be accepted by the daemon, hence leading to a denial of service.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.