Lesson plan

Sludging

Sludging is a very simple well drilling method developed in ancient India but still used extensively in developing countries, where capital is scarce, but manpower abundant. A pipe is moved up and down in a hole filled with water (mud). Every time the pipe hits the bottom, some soil material is loosened and suspended into the drilling mud, which is continuously pumped out of the borehole by a valve, taking advantage of the same reciprocating movement. In its basic form, a bamboo pipe (internal knots removed) is used, and the operator uses his hand on top of this pipe as a valve. On upstroke, a vacuum is created in the pipe under the operator's hand and the column of mud in the pipe is lifted. On downstroke, new mud enters the pipe from beneath and the upper portion is expulsed. For wells deeper than about 10 metres, and especially when heavier metal drill pipe is used, a lifting device is installed. This ranges from a rope over a pulley or a pole, attached to the drill pipe with a rope and used as a lever. In this case, the driller only acts on downstroke, giving an extra push to the drill stem, while the upward movement is assured by other workers, pulling the rope or pushing down the lever, or by a small motor.…

Back to article

Article summary

Sludging is a very simple well drilling method developed in ancient India but still used extensively in developing countries, where capital is scarce, but manpower abundant. A pipe is moved up and down in a hole filled with water (mud). Every time the pipe hits the bottom, some soil material is loosened and suspended into the drilling mud, which is continuously pumped out of the borehole by a valve, taking advantage of the same reciprocating movement. In its basic form, a bamboo pipe (internal knots removed) is used, and the operator uses his hand on top of this pipe as a valve. On upstroke, a vacuum is created in the pipe under the operator's hand and the column of mud in the pipe is lifted. On downstroke, new mud enters the pipe from beneath and the upper portion is expulsed. For wells deeper than about 10 metres, and especially when heavier metal drill pipe is used, a lifting device is installed. This ranges from a rope over a pulley or a pole, attached to the drill pipe with a rope and used as a lever. In this case, the driller only acts on downstroke, giving an extra push to the drill stem, while the upward movement is assured by other workers, pulling the rope or pushing down the lever, or by a small motor.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.