Lesson plan

Span (engineering)

In engineering, span is the distance between two adjacent structural supports (e.g., two piers) of a structural member (e.g., a beam). Span is measured in the horizontal direction either between the faces of the supports (clear span) or between the centers of the bearing surfaces (effective span). For a bridge, the total span is the distance between the faces of the abutments: A span can be closed by a solid beam or by a rope. The first kind is used for bridges, the second one for power lines, overhead telecommunication lines, some type of antennas or for aerial tramways. beam (top) bending under an evenly distributed load (bottom). Span is a significant factor in finding the strength and size of a beam as it determines the maximum bending moment and deflection. The maximum bending moment M_{max} and deflection \delta_{max} in the pictured beam is found using: : M_{max} = \frac {q L^2} {8} : \delta_{max} = \frac {5 M_{max} L^2} {48 E I} = \frac {5 q L^4} {384 E I} where : q = Uniformly distributed load : L = Length of the beam between two supports (span) : E = Modulus of elasticity : I = Area moment of inertia The maximum bending moment and deflection occur midway between the two supports. From this it follows that if the span is doubled, the maximum moment (and with it the stress) will quadruple, and deflection will increase by a factor of sixteen.

Back to article

Article summary

In engineering, span is the distance between two adjacent structural supports (e.g., two piers) of a structural member (e.g., a beam). Span is measured in the horizontal direction either between the faces of the supports (clear span) or between the centers of the bearing surfaces (effective span). For a bridge, the total span is the distance between the faces of the abutments: A span can be closed by a solid beam or by a rope. The first kind is used for bridges, the second one for power lines, overhead telecommunication lines, some type of antennas or for aerial tramways. beam (top) bending under an evenly distributed load (bottom). Span is a significant factor in finding the strength and size of a beam as it determines the maximum bending moment and deflection. The maximum bending moment M_{max} and deflection \delta_{max} in the pictured beam is found using: : M_{max} = \frac {q L^2} {8} : \delta_{max} = \frac {5 M_{max} L^2} {48 E I} = \frac {5 q L^4} {384 E I} where : q = Uniformly distributed load : L = Length of the beam between two supports (span) : E = Modulus of elasticity : I = Area moment of inertia The maximum bending moment and deflection occur midway between the two supports. From this it follows that if the span is doubled, the maximum moment (and with it the stress) will quadruple, and deflection will increase by a factor of sixteen.

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.