Lesson plan

Speed ring

A speed ring is a solid metal ring-shaped disk which is used to attach a soft box to a studio (strobe) or continuous (hotlight) light source. There are 4 to 8 holes drilled into the circumference of the ring which receives the metal rods of the soft box; they are held in place by tension. Shapes can vary depending on the manufacturer. Typically, the opening in the center ranges from 4 to 7 inches, allowing the light source to enter the softbox or other modifier. Common ring types are Bowens, Profoto, and Alien Bees.

Back to article

Article summary

A speed ring is a solid metal ring-shaped disk which is used to attach a soft box to a studio (strobe) or continuous (hotlight) light source. There are 4 to 8 holes drilled into the circumference of the ring which receives the metal rods of the soft box; they are held in place by tension. Shapes can vary depending on the manufacturer. Typically, the opening in the center ranges from 4 to 7 inches, allowing the light source to enter the softbox or other modifier. Common ring types are Bowens, Profoto, and Alien Bees.

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.