Lesson plan
Speedwire
Speedwire is a solderless prototyping system manufactured by BICC-Vero for constructing electronic circuit boards. The system is based on a circuit board pre-drilled with holes in a regular 0.1-inch (2.54 mm) square grid. The boards are available in standard sizes such as Eurocard modules. Some of the holes are through-plated and interconnected with copper strips to form power and ground rails. Special terminals are provided, which are inserted, using a special tool, into the holes in the prototyping board where components are to be fitted. Some boards are also available pre-populated with terminals. Each terminal is a metal tube with a component socket at one end and an insulation-displacement fork at the other. The component socket accepts a wire lead, such as the lead of a resistor or capacitor, or the leg of a 0.1-inch-pitch DIL package. The insulation-displacement fork accepts an insulated wire specially manufactured for the Speedwire system. The wire is pressed between the forks using a special tool. The forks cut through the insulation and grip the wire, making a gas-tight contact. The wire can then be cut off, or continued to another terminal. Wires can be pulled out of terminals and re-routed.
Article summary
Speedwire is a solderless prototyping system manufactured by BICC-Vero for constructing electronic circuit boards. The system is based on a circuit board pre-drilled with holes in a regular 0.1-inch (2.54 mm) square grid. The boards are available in standard sizes such as Eurocard modules. Some of the holes are through-plated and interconnected with copper strips to form power and ground rails. Special terminals are provided, which are inserted, using a special tool, into the holes in the prototyping board where components are to be fitted. Some boards are also available pre-populated with terminals. Each terminal is a metal tube with a component socket at one end and an insulation-displacement fork at the other. The component socket accepts a wire lead, such as the lead of a resistor or capacitor, or the leg of a 0.1-inch-pitch DIL package. The insulation-displacement fork accepts an insulated wire specially manufactured for the Speedwire system. The wire is pressed between the forks using a special tool. The forks cut through the insulation and grip the wire, making a gas-tight contact. The wire can then be cut off, or continued to another terminal. Wires can be pulled out of terminals and re-routed.
Key claims
No claims recorded.
Discussion questions
- Summarise the article in your own words. Which single claim would you verify first, and why?
- Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
- If two sources disagreed about one of these facts, what would you need in order to trust one over the other?
Bibliography
No sources recorded.
Key claims and bibliography are generated from the same tracked claims and sources as the article page.