Lesson plan

Stage loading

Stage Loading is a measure of the load on a turbomachinery stage, be it a part of a compressor, fan or turbine. The parameter, which is non-dimensional, is defined as: L = \frac{gJ{\Delta}H}{U^2} where: Imperial Units (SI Units) g acceleration of gravity ft/s/s (1.0) J mechanical equivalent of heat ft.lb/(s.hp) (1.0) {\Delta}H change in specific enthalpy over stage hp.s/lb (KW.s/Kg) U peripheral blade speed ft/s (m/s) Average stage loading has a very similar definition, where the number of stages, n, within the compressor, fan or turbine is used to provide an average value: L = \frac{gJ{\Delta}H}{nU^2} In this case the change in enthalpy is across the whole unit, not just a stage. Similarly, the blade speed used is a mean for the whole device. The above equation shows that if blade speed cannot be increased for, say, mechanical or aerodynamic reasons, the number of stages has to be increased to get the average stage loading back to an acceptable level, to obtain a satisfactory level of efficiency. The ideal average stage loading for a turbine is about 1.8.

Back to article

Article summary

Stage Loading is a measure of the load on a turbomachinery stage, be it a part of a compressor, fan or turbine. The parameter, which is non-dimensional, is defined as: L = \frac{gJ{\Delta}H}{U^2} where: Imperial Units (SI Units) g acceleration of gravity ft/s/s (1.0) J mechanical equivalent of heat ft.lb/(s.hp) (1.0) {\Delta}H change in specific enthalpy over stage hp.s/lb (KW.s/Kg) U peripheral blade speed ft/s (m/s) Average stage loading has a very similar definition, where the number of stages, n, within the compressor, fan or turbine is used to provide an average value: L = \frac{gJ{\Delta}H}{nU^2} In this case the change in enthalpy is across the whole unit, not just a stage. Similarly, the blade speed used is a mean for the whole device. The above equation shows that if blade speed cannot be increased for, say, mechanical or aerodynamic reasons, the number of stages has to be increased to get the average stage loading back to an acceptable level, to obtain a satisfactory level of efficiency. The ideal average stage loading for a turbine is about 1.8.

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.