Strouhal number

In dimensional analysis, the Strouhal number (St, or sometimes Sr to avoid the conflict with the Stanton number) is a dimensionless number describing oscillating flow mechanisms.

Uses your system voice; voice and rate in settings.

≈ 9 min read

Cite, export and learn8 citation formats · 8 exports · lesson and quiz

Names in other languages

No names in other languages are held for this entry yet.

Article bodies are English and are not machine-translated. A name in another language is not a translation of the article.

In dimensional analysis, the Strouhal number (St, or sometimes Sr to avoid the conflict with the Stanton number) is a dimensionless number describing oscillating flow mechanisms. The parameter is named after Vincenc Strouhal, a Czech physicist who experimented in 1878 with wires experiencing vortex shedding and singing in the wind.

The Strouhal number is an integral part of the fundamentals of fluid mechanics. The Strouhal number is often given as \text{St} = \frac{f L}{U}, where f is the frequency of vortex shedding in Hertz, L is the characteristic length (for example, hydraulic diameter or airfoil thickness), and U is the average flow speed in meters per second.

In certain cases, like heaving (plunging) flight, this characteristic length is the amplitude of oscillation. This selection of characteristic length can be used to present a distinction between Strouhal number and reduced frequency: \text{St} = \frac{k A}{\pi c}, where k is the reduced frequency, and A is amplitude of the heaving oscillation.

In the case of uniform flow past a fixed cylinder, the cylinder's diameter is the characteristic length. In that case, the Strouhal number is a function of the Reynolds number based on diameter, \mathrm{Re}_D = \rho V D/\mu , where \rho is the fluid's density (kg/m 3 ) and \mu [kg-m/s] is the fluid's dynamic viscosity.

Over four orders of magnitude in Reynolds number, from 10 2 to 10 5 , the value of the Strouhal number remains close to 0.2 (see figure). For spheres in uniform flow in the Reynolds number range of 8×10 2 5 there co-exist two values of the Strouhal number.

The lower frequency is attributed to the large-scale instability of the wake, is independent of the Reynolds number Re, and is approximately equal to 0.2. The higher-frequency Strouhal number is caused by small-scale instabilities from the separation of the shear layer.

For large Strouhal numbers (order of 1), viscosity dominates fluid flow, resulting in a collective oscillating movement of the fluid "plug". For low Strouhal numbers (order of 10 −4 and below), the high-speed, quasi-steady-state portion of the movement dominates the oscillation.

Oscillation at intermediate Strouhal numbers is characterized by the buildup and rapidly subsequent shedding of vortices. Knowing Newton's second law stating force is equivalent to mass times acceleration, or F=ma , and that acceleration is the derivative of velocity, or \tfrac{U}{t} (characteristic speed/time) in the case of fluid mechanics, we see F=\dfrac{mU}{t} , Since characteristic speed can be represented as length per unit time, \tfrac{L}{t} , we get F=\dfrac{mU^2}{L} , where, m = mass, U = characteristic speed, L = characteristic length.

Dividing both sides by \tfrac{mU^2}{L} , we get \tfrac{FL}{mU^2}=1=\text{constant} ⇒ \tfrac{mU^2}{FL}=1=\text{constant} , where, m = mass, U = characteristic speed, F = net external forces, L = characteristic length. This provides a dimensionless basis for a relationship between mass, characteristic speed, net external forces, and length (size) which can be used to analyze the effects of fluid mechanics on a body with mass.

If the net external forces are predominantly elastic, we can use Hooke's law to see F=k\Delta L , where, k = spring constant (stiffness of elastic element), ΔL = deformation (change in length). Assuming \Delta L\propto L , then F\approx kL .

With the natural resonant frequency of the elastic system, \omega_0^2 , being equal to \tfrac{k}{m} , we get \dfrac{mU^2}{FL}=\dfrac{mU^2}{kL^2}=\dfrac{U^2}{\omega_0^2L^2} , where, m = mass, U = characteristic speed, \omega_0 = natural resonant frequency, ΔL = deformation (change in length). Given that cyclic motion frequency can be represented by f=\tfrac{\omega_0^2L}{U} we get, \dfrac{U^2}{\omega_0^2L^2}=\dfrac{U}{fL}=\text{constant}=\dfrac{fL}{U}=\text{St (Strouhal Number)} , where, f = frequency, L = characteristic length, U = characteristic speed.

Micro/Nanorobotics

In the field of micro and nanorobotics, the Strouhal number is used alongside the Reynolds number in analyzing the impact of an external oscillatory fluidic flow on the body of a microrobot. When considering a microrobot with cyclic motion, the Strouhal number can be evaluated as \text{St} = \dfrac{fL}{U} , where, f = cyclic motion frequency, L = characteristic length of robot, U = characteristic speed.

The analysis of a microrobot using the Strouhal number allows one to assess the impact that the motion of the fluid it is in has on its motion in relation to the inertial forces acting on the robot–regardless of the dominant forces being elastic or not.

Medical

In the medical field, microrobots that use swimming motions to move may make micromanipulations in unreachable environments. The equation used for a blood vessel: \text{St} = \dfrac{fD}{V} , where, f = oscillation frequency of the microbot swimming motion D = blood vessel diameter V = unsteady viscoelastic flow The Strouhal number is used as a ratio of the Deborah number (De) and Weissenberg number (Wi): \text{St} = \dfrac{\text{De}}{\text{Wi}} .

The Strouhal number may also be used to obtain the Womersley number (Wo). The case for blood flow can be categorized as an unsteady viscoelastic flow, therefore the Womersley number is \text{Wo} = \sqrt{\dfrac{\pi}{2} \times \text{Re} \times \text{St}} , Or considering both equations, \text{Wo} = \sqrt{\dfrac{\pi}{2} \times \text{Re} \times \dfrac{\text{De}}{\text{Wi}}} .

Metrology

In metrology, specifically axial-flow turbine meters, the Strouhal number is used in combination with the Roshko number to give a correlation between flow rate and frequency. The advantage of this method over the frequency/viscosity versus K-factor method is that it takes into account temperature effects on the meter. \text{St}=\frac{f}{U} C^3, where, f = meter frequency, U = flow rate, C = linear coefficient of expansion for the meter housing material.

This relationship leaves Strouhal dimensionless, although a dimensionless approximation is often used for C 3 , resulting in units of pulses/volume (same as K-factor). This relationship between flow and frequency can also be found in the aeronautical field.

Considering pulsating methane-air coflow jet diffusion flames, we get \text{St} = \dfrac{aw_j}{U_j} , where, a = fuel jet radius w = the modulation frequency U = exit velocity of the fuel jet For a small Strouhal number (St=0.1) the modulation forms a deviation in the flow that travels very far downstream. As the Strouhal number grows, the non-dimensional frequency approaches the natural frequency of a flickering flame, and eventually will have greater pulsation than the flame.

Animal locomotion

In swimming or flying animals, Strouhal number is defined as \text{St} = \frac{f}{U} A, where, f = oscillation frequency (tail-beat, wing-flapping, etc.), U = flow rate, A = peak-to-peak oscillation amplitude. In animal flight or swimming, propulsive efficiency is high over a narrow range of Strouhal constants, generally peaking in the 0.2 \tfrac{mU^2}{FL} , we can then relate each term to size and see how the ratio changes as size changes.

Given m=V\rho where m is mass, V is volume, and \rho is density, we can see mass is directly related to size as volume scales with length (L). Taking the volume to be L^3 , we can directly relate mass and size as m \approx L^3 . Characteristic speed (U) is in terms of \tfrac{\text{distance}}{\text{time}} , and relative distance scales with size, therefore U^2 \approx L^2 .

The net external forces (F) scales in relation to mass and acceleration, given by F=m\cdot a . Acceleration is in terms of \tfrac{\text{distance}}{\text{time}^2} , therefore a \approx L . The mass-size relationship was established to be m \approx L^3 , so considering all three relationships, we get F \approx L^4 . Length (L) already denotes size and remains L. Taking all of this together, we get \dfrac{mU^2}{FL} \approx \dfrac{L^3L^2}{L^4L} \approx \dfrac{L^5}{L^5} \approx L^0 = 1 .

With the Strouhal number relating the mass to inertial forces, this can be expected as these two factors will scale proportionately with size and neither will increase nor decrease in significance with respect to their contribution to the body's behavior in the cyclic motion of the fluid.

Relationship with the Richardson number

The scaling relationship between the Richardson number and the Strouhal number is represented by the equation: \text{St}_l = b\text{Ri}_l^a , where a and b are constants depending on the condition. For round helium buoyant jets and plumes: \text{St}_D \sim \text{Ri}_D^{0.38} . When \text{Ri} , \text{St}_D = 0.8\text{Ri}_D^{0.38} .

When 100 , \text{St}_D = 2.1\text{Ri}_D^{0.28} . For planar buoyant jets and plumes: \text{St}_W = 0.55\text{Ri}_W^{0.45} . For shape-independent scaling: \text{St}_{Rh} = e^{-1}\text{Ri}_{Rh}^{\tfrac{2}{5}}

Relationship with Reynolds number

The Strouhal number and Reynolds number must be considered when addressing the ideal method to develop a body made to move through a fluid. Furthermore, the relationship for these values is expressed through Lighthill's elongated-body theory, which relates the reactive forces experienced by a body moving through a fluid with its inertial forces.

The Strouhal number was determined to depend upon the dimensionless Lighthill number, which in turn relates to the Reynolds number. The value of the Strouhal number can then be seen to decrease with an increasing Reynolds number, and to increase with an increasing Lighthill number.

Vincenc Strouhal, Ueber eine besondere Art der Tonerregung

Text derived from https://en.wikipedia.org/w/index.php?oldid=1371814474 under CC BY-SA 4.0; modifications have been made.

Words in each sectionAnimal locomotionAnimal locomotionAnimal locomotion: 286 words286MetrologyMetrologyMetrology: 189 words189MedicalMedicalMedical: 132 words132Micro/NanoroboticsMicro/NanoroboticsMicro/Nanorobotics: 111 words111Relationship with the R…Relationship with the Richardson numberRelationship with the Richardson number: 105 words105Relationship with Reyno…Relationship with Reynolds numberRelationship with Reynolds number: 100 words100
Words in each section. Measured from the stored article body; sections below the minimum are not plotted.

Provenance

snapshot enwiki-001371814474 · captured 2026-08-28 · ledger · version history

Cite this page as: encyclopegia.org, “Strouhal number”, snapshot enwiki-001371814474. https://encyclopegia.org/a/strouhal-number

Sources cited in this revision

9 named source(s) extracted from the cited revision. A source with no author is shown by its publication; nothing is invented.