Lesson plan

Switch virtual interface

A switch virtual interface (SVI) or routed VLAN interface (RVI) is a virtual network interface that represents a logical layer-3 interface on a multilayer network switch. VLANs divide broadcast domains in a local area network (LAN) environment. Whenever hosts in one VLAN need to communicate with hosts in another VLAN, the traffic must be routed between them. This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). An SVI is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device. Only one VLAN interface can be associated with a VLAN, but you need to configure a VLAN interface for a VLAN only when you want to route between VLANs or to provide IP host connectivity to the device through a virtual routing and forwarding (VRF) instance that is not the management VRF. When you enable VLAN interface creation, a switch creates a VLAN interface for the default VLAN (VLAN 1) to permit remote switch administration. SVIs are generally configured for a VLAN for the following reasons: * To allow traffic to be routed between VLANs by providing a default gateway for the VLAN. * To provide fallback bridging (if required for non-routable protocols). * To provide Layer 3 IP connectivity to the switch. * To support bridging configurations and routing protocol.…

Back to article

Article summary

A switch virtual interface (SVI) or routed VLAN interface (RVI) is a virtual network interface that represents a logical layer-3 interface on a multilayer network switch. VLANs divide broadcast domains in a local area network (LAN) environment. Whenever hosts in one VLAN need to communicate with hosts in another VLAN, the traffic must be routed between them. This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). An SVI is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device. Only one VLAN interface can be associated with a VLAN, but you need to configure a VLAN interface for a VLAN only when you want to route between VLANs or to provide IP host connectivity to the device through a virtual routing and forwarding (VRF) instance that is not the management VRF. When you enable VLAN interface creation, a switch creates a VLAN interface for the default VLAN (VLAN 1) to permit remote switch administration. SVIs are generally configured for a VLAN for the following reasons: * To allow traffic to be routed between VLANs by providing a default gateway for the VLAN. * To provide fallback bridging (if required for non-routable protocols). * To provide Layer 3 IP connectivity to the switch. * To support bridging configurations and routing protocol.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.