Lesson plan

Test register

A test register, in the Intel 80386 and Intel 80486 processors, was a register used by the processor, usually to do a self-test. Most of these registers were undocumented, and used by specialized software. The test registers were named TR3 to TR7. Regular programs don't usually require these registers to work. With the Pentium, the test registers were replaced by a variety of model-specific registers (MSRs). In the 80386, two test registers, TR6 and TR7, were provided for the purpose of TLB testing. TR6 was the test command register, and TR7 was the test data register. The 80486 provided three additional registers, TR3, TR4 and TR5, for testing of the L1 cache. TR3 was a data register, TR4 was an address register and TR5 was a command register. These registers were accessed by variants of the MOV instruction. A test register may either be the source operand or the destination operand. The MOV instructions are defined in both real-address mode and protected mode. The test registers are privileged resources. In protected mode, the MOV instructions that access them can only be executed at privilege level 0. An attempt to read or write the test registers when executing at any other privilege level causes a general protection exception. Also, those instructions generate invalid opcode exception on most CPUs newer than 80486.…

Back to article

Article summary

A test register, in the Intel 80386 and Intel 80486 processors, was a register used by the processor, usually to do a self-test. Most of these registers were undocumented, and used by specialized software. The test registers were named TR3 to TR7. Regular programs don't usually require these registers to work. With the Pentium, the test registers were replaced by a variety of model-specific registers (MSRs). In the 80386, two test registers, TR6 and TR7, were provided for the purpose of TLB testing. TR6 was the test command register, and TR7 was the test data register. The 80486 provided three additional registers, TR3, TR4 and TR5, for testing of the L1 cache. TR3 was a data register, TR4 was an address register and TR5 was a command register. These registers were accessed by variants of the MOV instruction. A test register may either be the source operand or the destination operand. The MOV instructions are defined in both real-address mode and protected mode. The test registers are privileged resources. In protected mode, the MOV instructions that access them can only be executed at privilege level 0. An attempt to read or write the test registers when executing at any other privilege level causes a general protection exception. Also, those instructions generate invalid opcode exception on most CPUs newer than 80486.…

Key claims

No claims recorded.

Discussion questions

  1. Summarise the article in your own words. Which single claim would you verify first, and why?
  2. Which claim in this article is most likely to be revised as the sources update? How would you check its current status?
  3. If two sources disagreed about one of these facts, what would you need in order to trust one over the other?

Bibliography

No sources recorded.

Key claims and bibliography are generated from the same tracked claims and sources as the article page.